Studies on structural, electrical and electrochemical properties of biodegradable PVP/starch blend polymer electrolytes with ammonium ceric nitrate for energy storage devices

Biopolymer composite electrolytes consisting of cellulose acetate and magnesium perchlorate with different weight percent (wt.%) of Zinc Oxide fillers were prepared using the standard solution cast technique. The effect of incorporating various amounts of ZnO fillers in our composite electrolytes was investigated for their electrical and structural properties, and ion transference numbers. The ionic conductivity of 40 wt.% ZnO filler was found to be 8.75× 10−4 S/cm at 30 °C along with a 4.2 V electrochemical stability window. The ion transference number has been found to be 0.97 for CA + 40 wt.% of Mg(ClO4)2 + 40 wt.% with ZnO fillers. Furthermore, the electrochemical performances of the prepared electrolytes have also been investigated. The fabricated cell with this electrolyte shows an enhanced energy and high-power density of 2.78 Wh/Kg and 1000 W/Kg, respectively. An increase in the above-mentioned densities may be attributed to the high ionic conductivity ZnO fillers in the biopolymer matrix. Additionally, it shows 100% capacitance retention along with high coulombic efficiency after the 129th cycle.

show abstract

Improved performance of biopolymer composite electrolyte based cellulose acetate/Zinc Oxide filler for supercapacitors

Sadiq

Khan

Raza

et al. 2023

Energy & Environment

View full text Add to dashboard Cite

show abstract

Influence of Lithium Triflate Salt Concentration on Structural, Thermal, Electrochemical, and Ionic Conductivity Properties of Cassava Starch Solid Biopolymer Electrolytes

Arrieta,

Calabokis,

Vanegas

2024

IJMS

View full text Add to dashboard Cite

Cassava starch solid biopolymer electrolyte (SBPE) films were prepared by a thermochemical method with different concentrations of lithium triflate (LiTFT) as a dopant salt. The process began with dispersing cassava starch in water, followed by heating to facilitate gelatinization; subsequently, plasticizers and LiTFT were added at differing concentrations. The infrared spectroscopy analysis (FTIR-ATR) showed variations in the wavenumber of some characteristic bands of starch, thus evidencing the interaction between the LiTFT salt and biopolymeric matrix. The short-range crystallinity index, determined by the ratio of COH to COC bands, exhibited the highest crystallinity in the salt-free SBPEs and the lowest in the SBPEs with a concentration ratio (Xm) of 0.17. The thermogravimetric analysis demonstrated that the salt addition increased the dehydration process temperature by 5 °C. Additionally, the thermal decomposition processes were shown at lower temperatures after the addition of the LiTFT salt into the SBPEs. The differential scanning calorimetry showed that the addition of the salt affected the endothermic process related to the degradation of the packing of the starch molecules, which occurred at 70 °C in the salt-free SBPEs and at lower temperatures (2 or 3 °C less) in the films that contained the LiTFT salt at different concentrations. The cyclic voltammetry analysis of the SBPE films identified the redox processes of the glucose units in all the samples, with observed differences in peak potentials (Ep) and peak currents (Ip) across various salt concentrations. Electrochemical impedance spectroscopy was used to establish the equivalent circuit model Rf–(Cdl/(Rct–(CPE/Rre))) and determine the electrochemical parameters, revealing a higher conduction value of 2.72 × 10−3 S cm−1 for the SBPEs with Xm = 17 and a lower conduction of 5.80 × 10−4 S cm−1 in the salt-free SBPEs. It was concluded that the concentration of LiTFT salt in the cassava starch SBPE films influences their morphology and slightly reduces their thermal stability. Furthermore, the electrochemical behavior is affected in terms of variations in the redox potentials of the glucose units of the biopolymer and in their ionic conductivity.

show abstract

scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.

Contact Info

hi@scite.ai

10624 S. Eastern Ave., Ste. A-614

Henderson, NV 89052, USA

Blog Terms and Conditions API Terms Privacy Policy Contact Cookie Preferences Do Not Sell or Share My Personal Information

Made with 💙 for researchers

Part of the Research Solutions Family.

Studies on structural, electrical and electrochemical properties of biodegradable PVP/starch blend polymer electrolytes with ammonium ceric nitrate for energy storage devices

Cited by 2 publications

References 49 publications

Improved performance of biopolymer composite electrolyte based cellulose acetate/Zinc Oxide filler for supercapacitors

Improved performance of biopolymer composite electrolyte based cellulose acetate/Zinc Oxide filler for supercapacitors

Influence of Lithium Triflate Salt Concentration on Structural, Thermal, Electrochemical, and Ionic Conductivity Properties of Cassava Starch Solid Biopolymer Electrolytes

Contact Info

Product

Resources

About