Structures and morphologies of in situ polymerized blends of PMMA and ASA

Abstract

Blends of poly(methyl methacrylate), PMMA, and the elastomer ASA, a graft copolymer based on poly(acrylonitrile‐co‐styrene) (SAN) and acrylic rubber, were prepared by in situ polymerization and characterized according to structural, mechanical, thermal, and morphological properties. The polymerization conditions, such the presence or absence of a chain transfer agent, stirring and an inert atmosphere, influence the morphological and structural properties of the blends. In spite of the evidences of the partial miscibility between PMMA and SAN phase of the ASA, the blends are heterogeneous and present a complex morphology. The morphology of some PMMA‐ASA blends is made up of an elastomeric dispersed phase in a glassy matrix, with a possible inclusion of the matrix in the elastomeric domains. The selective extraction of the blend components and infrared spectroscopy showed that crosslinking and/or grafting reactions occur on ASA chains during MMA polymerization. The syndiotacticity of PMMA obtained in the presence of ASA increases with the amount of ASA, due to possible interactions between the carbonyl groups of PMMA and the nitrile or phenyl groups of the SAN copolymer. The mechanical properties of the blends were influenced by the compositions of the blends and mainly by the conditions of polymerization. © 2013 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2013

Rheological, mechanical and morphological properties of poly(methyl methacrylate)/poly(ethylene terephthalate) blend with dual reactive interfacial compatibilization

“…However, PMMA is brittle at room temperature with low elongation at break and low impact strength. A very common method to promote improvements in the mechanical properties of PMMA is its toughening with elastomers [7][8][9][10][11][12] . The addition of elastomers in PMMA become the polymer opaque and lose transparency, one of its most important characteristics of this material.…”

Improvement of mechanical-antibacterial performances of AR/PMMA with TiO2and HPQM treated by N-2(aminoethyl)-3-aminopropyl trimethoxysilane

“…17 who claimed that the TiO 2 and silane coupling agent could interact with each other through Ti-O-Si bonding. 18–21 Occurrences of the good dispersibility and chemical bonding of treated TiO 2 were claimed to improve the mechanical properties of the matrix. This claim was in good agreement with the findings of Ambrósio et al.…”

Influence of acrylic content in PBA‐SAN on the mechanical properties of PBA‐SAN and PBA‐SAN/SAN blends

“…Therefore, ASA makes good performance on aging problems. A number of reports for ASA and its blends can be found, such as ASA/SAN blends , ASA/polycarbonate (PC) blends , ASA/poly(ethylene terephthalate) (PET) blends , ASA/poly(butylene terephthalate) (PBT) blends , ASA/poly(vinyl chloride) (PVC) , ASA/poly (methyl methacrylate) (PMMA) , ASA/chlorinated polyethylene (CPE) , PVC/poly (α‐methylstyrene‐acrylonitrile)/CPE/ASA . In general, via adjusting the ratios between different polymeric components, the balances between different properties of ASA resin can be tunnelled and achieved.…”