Structure Parameter of Electrorheological Fluids in Shear Flow

Abstract

A structure parameter, Sn = η(c)γ/τ(E), is proposed to represent the increase of effective viscosity due to the introduction of particles into a viscous liquid and to analyze the shear behavior of electrorheological (ER) fluids. Sn can divide the shear curves of ER fluids, τ/E(2) versus Sn, into three regimes, with two critical values Sn(c) of about 10(-4) and 10(-2), respectively. The two critical Sn(c) are applicable to ER fluids with different particle volume fractions φ in a wide range of shear rate γ and electric field E. When Sn < 10(-4), the shear behavior of ER fluids is mainly dominated by E and by shear rate when Sn > 10(-2). The electric current of ER fluids under E varied with shear stress in the same or the opposite trend in different shear rate ranges. Sn(c) also separates the conductivity variation of ER fluids into three regimes, corresponding to different structure evolutions. The change of Sn with particle volume fraction and E has also been discussed. The shear thickening in ER fluids can be characterized by Sn(c)(L) and Sn(c)(H) with a critical value about 10(-6). As an analogy to friction, the correspondence between τ/E(2) and friction coefficient, Sn and bearing numbers, as well as the similarity between the shear curve of ER fluids and the Stribeck curve of friction, indicate a possible friction origin in ER effect.

Facile fabrication of self-assembled PMMA/graphene oxide composite particles and their electroresponsive properties

“…Here, the ER fluid is a type of smart material that is composed of electrically polarizable particles dispersed in insulating oil and exhibits a rapid liquidlike to solid-like phase transition under an applied electric field [14][15][16][17]. The main mechanism suggests that all particles within the medium are polarized under applied electric field and attach to adjacent particles to form chains or fibrillated structures towards the field.…”

Polypyrrole-wrapped halloysite nanocomposite and its rheological response under electric fields

“…7a. Without an applied electric field, the shear stress increased monotonically with increasing shear rate, similar to Newtonian-like fluid behavior with a slight deviation in which the shear stress is more likely linearly proportional to the shear rate, whereas this ER fluid exhibited higher shear stresses with increasing electric field strengths at all shear rates [36]. In addition, at each electric field strength, the shear stress exhibited a plateau in the low shear rate region.…”

Giant electrorheological fluids with ultrahigh electrorheological efficiency based on a micro/nano hybrid calcium titanyl oxalate composite

“…Despite these advantages, ER fluids have suffered as a result of their inferior yield stress, which yields poor mechanical performance that limits their application. [11][12][13][14] The discovery of the giant ER (GER) effect has revived interest in this area. Compared with conventional ER fluids, GER fluids exhibit yield stresses that are almost an order of magnitude higher.…”