Structural and magnetic characterization of 100-kGy Co60 γ-ray-irradiated ZnFe2O4 NPs by XRD, W–H plot and ESR

Abstract

Nanocrystalline spinel ferrite was prepared by sol-gel auto-combustion technique and sintered at 600°C for 12 h. Single-phase cubic spinel structure of zinc ferrite was confirmed through X-ray diffractometry. Several structural and magnetic properties of ZnFe 2 O 4 NPs were studied after Co 60 c-irradiation with total gamma dose of 50 and 100 kGy. An average crystallite size was determined from the full width at half maximum of strongest reflection (311) by using Scherrer's approximation. Williamson-Hall plot (graph against bcosh and 4sinh) was used to re-evaluate the measured crystallite size and to estimate the strain distribution in terms of g%. Lattice constant (a) initially increased slightly to 8.441 Å with c-50 kGy and then decreased dramatically with total dose of c-100 kGy. Frustrated behaviour in peak shift to lower and higher 2h side can be seen in XRD after c-irradiation to ZnFe 2 O 4 NPs. FT-IR spectra confirmed the formation of ferrite phase and redistribution of cations in (A) and [B] sites of ZnFe 2 O 4 spinel structure. In the first derivative peak of ESR spectroscopy, gyroscopic spitting factor (g-value) and linewidth (DH PP ) were used to deliberate the c-radiation damage in investigated ferrimagnetic nanoparticles. Experimental results revealed that the saturation magnetization (M s ), coercivity (H c ) and magneton number (n B ) of ZnFe 2 O 4 NPs were found to be increased after gamma irradiation dose of c-100 kGy. Graphical AbstractKeywords Ferrite nanoparticles Á Sol-gel autocombustion Á Williamson-Hall plot Á ESR Á Radiation damage & Anil V. Raut

Solvothermal synthesis of porous Fe3O4 nanoparticles for humidity sensor application

“…Several studies have been performed into the use of the materials in drug delivery [4,5], magnetic resonance imaging (MRI) [6], hyperthermia [7,8], medical diagnosis and therapy [9,10] gas sensors [11][12][13], catalysts [14,15], and environmental remediation [16,17]. Several methods are used to synthesize magnetic material; e.g., sol-gel [18,19], reverse micelle [20], co-precipitation process [21,22], γ-ray irradiation [23,24], non-aqueous route [25], microwave plasma synthesis [26], and hydrothermal treatment [27,28]. Among these methods, solvothermal is a powerful technique to control the morphology and size of the nanostructure [29][30][31][32][33][34].…”