Strain-amplitude dependent cyclic hardening of 08Ch18N10T austenitic stainless steel

Fumfera, Jaromír; Džugan, Ján; Kuželka, Jiří; Procházka, Radek; Španiel, Miroslav

doi:10.1088/1757-899x/179/1/012026

Cited by 2 publications

(6 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…It can only be used for the materials where construction of the master curve is possible. 6 However, there are materials 11,13,14 for which the construction of the master curve is not possible (Figure 3B). For such cases, Yadav et al 11,12 have proposed a method based on a nondimensional parameter known as normalized CPSED difference.…”

Section: Change In Proportional Stress Limit (δσ 0 ) Methodsmentioning

confidence: 99%

“…The CPSED (Figure 19A) and fatigue life prediction (Figure 19B) could be made within a scatter band of 1.2 and 2, respectively 11,12 . The 13 different materials are 304L SS, 12 304LN SS, 16 316LN SS, 91 SA333 Gr.6, 16 AA6063, 79 AISI 1018 HR steel, 7 annealed Cu, 119 annealed Al, 119 BLY160 steel, 14 AISI 321 SS, 13 LY225 steel, 25 HSS Q960E, 88 and AL6XN steel 120 . The proposed method (Equation 12) is claimed to be universal in nature as it could be used for all those 13 materials, among which some were showing Masing behavior, and others were showing non‐Masing (Type‐I) and non‐Masing (Type‐II) behavior 11,12 …”

Section: Fatigue Life Prediction Of Masing/non‐masing Behaviormentioning

confidence: 95%

“…Variation of the cyclic plastic strain energy density with strain amplitude for Masing and non‐Masing behaviors of three different materials. The plots are generated by extracting the data for LY225 steel, 25 BLY160 steel, 14 and AISI 321 SS 13 . The data for Masing behavior were obtained by constructing the hysteresis loops for an idealized Masing behavior of the materials, as discussed in the article 12 .…”

Section: Introductionmentioning

confidence: 99%

“…In one category (Type-I), the materials 6,11 were found to exhibit non-Masing behavior, while the master curve could be constructed (Figure 3A). In another category (Type-II), a few other materials 11,13,14 were found to exhibit non-Masing behavior, while the master curve could not be constructed (Figure 3B). The latest classification of material behavior under LCF has been summarized in Figure 4.…”

Section: Introductionmentioning

confidence: 99%

“…The plots are generated by extracting the data for LY225 steel, 25 BLY160 steel, 14 and AISI 321 SS. 13 The data for Masing behavior were obtained by constructing the hysteresis loops for an idealized Masing behavior of the materials, as discussed in the article. 12 the fatigue behavior of materials or components.…”

Section: Introductionmentioning

confidence: 99%

See 4 more Smart Citations

A comprehensive review and analysis of Masing/non‐Masing behavior of materials under fatigue

Yadav

Roy

Goyal³

2022

Fatigue Fract Eng Mat Struct

View full text Add to dashboard Cite

Over the last 50 years, many researchers have contributed significantly towards understanding the Masing/non-Masing behavior of materials. However, there has been no review article or scientific report published to date that highlights the progress made in this domain. This article presents a state-ofthe-art comprehensive review and analysis of the Masing/non-Masing behavior of materials under low cycle fatigue loading. Understanding of Masing/ non-Masing behavior is important for the development of fatigue-resistant materials, prediction of fatigue life, and constitutive modeling and simulation. The influence of various factors such as stacking fault energy, temperature, strain amplitude, and loading conditions on Masing/non-Masing behavior has been summarized in this article. The literature pertaining to the internal microstructural changes observed in different materials by various researchers has been collected and compiled. The different methods of analyzing Masing/ non-Masing behavior reported in the open literature are assessed and presented. The importance/significance of Masing/non-Masing behavior in constitutive modeling and fatigue life prediction has also been highlighted. Finally, conclusions based on the review and the potential problems required to be resolved in the future are also pointed out.

show abstract