Stiffness and Deformation Analysis of Cross-Laminated Timber (CLT) Panels Made of Nordic Spruce Based on Experimental Testing, Analytical Calculation and Numerical Modeling

Dobeš, Pavel; Lokaj, Antonín; Vavrušová, Kristýna

doi:10.3390/buildings13010200

Cited by 5 publications

(1 citation statement)

References 32 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Timber structures have gained significant attention recently due to their sustainable and environmentally friendly nature [1][2][3]. Buildings and construction account for approximately 40% of global energy consumption and contribute 33% of greenhouse gas emissions [4].…”

Section: Introductionmentioning

confidence: 99%

The Quality Assessment of Timber Structural Joints Using the Coaxial Correlation Method

Kurtenoks,

Kurajevs,

Buka-Vaivade

et al. 2023

Buildings

View full text Add to dashboard Cite

With the growing popularity of timber structures, the requirement for reliable and non-destructive methods to assess the quality and condition of structural joints becomes increasingly essential. A novel coaxial correlations method is investigated to assess the degradation of panel-to-panel moment joints in timber structures. The method involves analysing the response data obtained from accelerometers placed on both sides of the joint and comparing the readings to evaluate the joint’s condition. A specific joint solution to simulate the degradation of the moment joint in laboratory conditions is selected based on its simplicity and the ease with which its degradation can be simulated. The joint consists of angle brackets joined with timber screws and bolts to plywood panels. Gradually unscrewing the timber screws reduces the joint’s stiffness to simulate wear and tear over time. The experimental setup includes static loading and finite element modelling (FEM) to determine the rotational stiffness of the investigated joint at each degradation level. A dynamic experiment using vibration loading with sweep signal in the frequency range of 10 Hz to 2000 Hz is conducted to assess the quality of the joint. The conducted research provides valuable insights into the behaviour of timber panel-to-panel connections. The findings highlight the relationship between joint stiffness, vertical displacements, and the proposed dimensionless parameter, volume root mean square value (RMSvol), which offers a more comprehensive assessment of the joint’s condition in three spatial directions. As a result of the research, it has been established that, in the case of linear-type connections, unlike point-type joints, there is a possibility of signal scattering, so it is recommended that power comparisons and evaluations of the response signals from both accelerometers at the initial stage of applying the coaxial correlations method are performed.

show abstract