Static test of the embedded fiber Bragg gratings composite wind turbine blades

Zhang, Zhichun; Huang, Zhong Guo; Liu, Yanjiu; Leng, Jinsong

doi:10.1117/12.880617

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Zhang et al reported the static testing of a small, 300 W turbine blade instrumented with FBG strain transducers. The experimental results were found to be in good agreement with the FEM results [10]. FBG based distributed strain sensor systems have also been used in a laboratory bench test of a wind turbine blade manufactured of a foam core and fiber reinforced face sheets, to determine the loading direction, location and magnitude of the imposed loads [11].…”

Section: Introductionsupporting

confidence: 60%

Development of a FBG based distributed strain sensor system for wind turbine structural health monitoring

Arsenault

Achuthan

Marzocca

et al. 2013

Smart Mater. Struct.

View full text Add to dashboard Cite

The development of a fiber Bragg grating (FBG) based distributed strain sensor system for real time structural health monitoring of a wind turbine rotor and its validation under a laboratory scale test setup is discussed in this paper. A 1 kW, 1.6 m diameter rotor, horizontal axis wind turbine with three instrumented blades is used in this study. The sensor system consists of strain sensors, surface mounted at various locations on the blade. At first the sensors are calibrated under static loading conditions to validate the FBG mounting and the proposed data collection techniques. Then, the capability of the sensor system coupled with the operational modal analysis (OMA) methods to capture natural frequencies and corresponding mode shapes in terms of distributed strains are validated under various non-rotating dynamic loading conditions. Finally, the sensor system is tested under rotating conditions using the wind flow from an open-jet wind tunnel, for both a baseline wind turbine and a wind turbine with a structurally modified blade. The blade was modified by attaching a lumped mass at the blade tip simulating structural damage or ice accretion. The dynamic characteristics of the baseline (healthy) blade and modified (altered) blade are compared to validate the sensor system’s ability for real time structural health monitoring of the rotor.

show abstract

Section: Introductionsupporting

confidence: 60%