Start-Up Current Spike Mitigation of High-Power Laser Diode Driving Controller for Vehicle Headlamp Applications

Abstract

A high-power laser diode driving controller (HPLDDC), which incorporates the power converter with the feedback controller, was developed and implemented in this paper. The synchronous buck–boost converter (SBBC) was the topology of the power converter; the SBBC could be operated in step-up or step-down mode in accordance with variable on-board battery voltage inputs into the HPLDDC. Moreover, the feedback controllers were equipped with a current-loop controller (CLC) and a voltage-loop controller (VLC); the VLC was employed to regulate the SBBC output voltage to drive and start-up the high-power laser diode (HPLD). The CLC was used to regulate the SBBC output current to supply a constant-current driving the HPLDs. During the start-up transient phase, when the SBBC output mode is changed from the constant-voltage to the constant-current, a start-up current spike occurs that can destroy the semiconductor material of the laser diode. However, few studies have discussed methods of coping with this problem. Therefore, this study proposed a proportional-integral associating proportional (PIAP) control technology, which can be applied to the CLC for the start-up current spike mitigation. Complete designs and analyses are presented in this paper. Simulations and experiments validate that the PIAP control method is effectual to solve the start-up current spike.

A Coordinated Wheeled Gas Pipeline Robot Chain System Based on Visible Light Relay Communication and Illuminance Assessment

“…As the most indispensable part of the VLC system, wave transmission module loads the modulated electrical signal onto the LEDs and converts electrical signals into optical signals. Since the current output of the main control ARM chip is too small, the modulated signal has to be amplified to display the change in LED optical power [28,29]. As illustrated in the LED driver of Figure 6, we selected two NPN S8050 transistors as the Darlington amplifier.…”

A Novel Design of Through-Hole Depth On-Machine Optical Measuring Equipment for Automatic Drilling and Riveting

“…The colour of the laser emitted by the laser transmitter in this device is bright red. Its Saturation is high because of its generation principle [28]. Therefore, the optimum range of the three parameters in image processing is Hue-160 to 179, Saturation-90 to 255, and Value-90 to 255.…”

Development and implementation of a laser headlight system for electro‐optic characteristic measurement and comparison

“…In Tiefenbacher, a safety apparatus was developed for controlling a laser headlight to avoid traffic accidents caused by uncontrolled headlights; this apparatus could avoid damage to human eyes engendered by direct laser exposure. A few studies have discussed systems for the operation and control of headlights …”

“…A few studies have discussed systems for the operation and control of headlights. [8][9][10][11][12][13] Dimming headlights by using analog modulation and PWM are prominent approaches to adjusting LED brightness. For dimming headlights by using analog modulation (analog dimming), the LED driving current is adjusted to vary its brightness.…”

“…The circuit configuration and control topology for laser headlights have been discussed in Pai et al In Xu et al, a laser headlight system was designed to receive data messages from an onboard media navigation system, which could be operated using an image processor; hence, a driving module could be used to modulate the pulse‐width modulation (PWM) duty cycle to control the color temperature and brightness of the headlight. In Stam, a headlight system was developed to control the headlight brightness and projection position in accordance with the driving environment; thus, the optimal illumination area could be obtained, and the glare of the headlight could be adjusted such that it does not influence opposite‐direction drivers.…”