Stagger procedure to extend the frequency modulated interrupted continuous wave technique to high resolution radars

Gonzalez-Partida, J.-T.; Burgos-García, M.; Dorta-Naranjo, B. Pablo; Pérez-Martínez, F.

doi:10.1049/iet-rsn:20060033

Cited by 6 publications

(1 citation statement)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…However, it should be noted that there are advanced concepts that warrant special consideration. For example, a switching process can be incorporated to achieve isolation between the transmit and receive paths when using a single antenna [29], [30], [31], or enable channel separation in multiple input multiple output (MIMO) concepts [32]. As a result, spurious components may already be present in the radar signal received by the RTS.…”

Section: B Applicability To Sensors Based On Advanced Modulationmentioning

confidence: 99%

A Simple and Versatile Concept to Improve Dynamic Range and Enable Target Angle Adaptability in Radar Target Simulators

Birkenhauer,

Körner,

Stief

et al. 2023

IEEE J. Microw.

View full text Add to dashboard Cite

Radar target simulators are not only a critical tool for verifying and testing radar systems but also play an important role in supporting the development of self-driving cars. Advances in radar sensors and techniques raise the required specifications for these units, increasing their complexity and cost. This article presents a novel and universal concept for radar target simulators that addresses these issues by responding only to the transmitted signal of a radar sensor during a fraction of the time, therefore modulating the average of the signal. This offers advantages for three independent use cases, which may be combined. First, the dynamic range and resolution of simulated target echo power can be improved even for existing systems. Second, the simulation of multiangle scenarios with a single backend is possible with this approach. Finally, hardware complexity and power consumption can be reduced. The proposed concept is examined extensively for frequency-modulated continuous wave radar, and design decisions are made. The theoretical considerations are validated with measurements with a real radar target simulator showing an improvement of up to 30 dB in the dynamic range with no observable negative side effects.INDEX TERMS Automotive radar, radar target simulator, TDM, radar signal processing, radar systems.

show abstract