Spectral and Atmospheric Characterization of a Site at Atacama Desert for Earth Observation Sensor Calibration

Abstract

Artículo de publicación ISIThe application of Earth observation sensor data in quantitative approaches calls on the conversion of original digital numbers to radiometric quantities such as radiance or reflectance. This conversion depends on the sensor absolute calibration. One of the postlaunch methods adopted to calibrate orbital sensors is the reflectance-based approach. According to this method, a reference surface with specifics characteristics is required. The main objective of this work is to evaluate the suitability of a specific surface located at Atacama Desert in Chile to be used as a reference surface for calibration of Earth observation sensor purposes. A field campaign was carried out from August 19 to 22, 2014, when radiometric measurements were performed to spectrally characterize the reference surface and to evaluate the atmospheric characteristics of the study area. The average reference surface reflectance factor in the spectral region from 350 to 2500 nm ranged from 0.1 to 0.3, and its spatial uniformity was within 2%-4%. The amount of atmospheric aerosols was low, with an aerosol optical depth at 550 nm between 0.08 and 0.11 during the fieldwork period. The climate is hyperarid, and the water column abundance was lower than 0.43 g/cm(2). The results demonstrated that a reference surface at Atacama Desert could be effectively used for calibration of either airborne or orbital electrooptical sensors, providing an excellent surface in South America.Conselho Nacional de Desenvolvimento Cientifico e Tecnologico (CNPq), Coordena, ao de Aperfeicoamento de Pessoal de Nivel Superior (CAPES), Fondecyt-Initial (CONICYT)

Calibration of the Ssot Mission Using a Vicarious Approach Based on Observations Over the Atacama Desert and the Gobabeb Radcalnet Station

“…Since the SSOT lacks on-board calibration infrastructure, this research has relied on vicarious methods, particularly using the reflectance-based approach (Thome at al., 2001). Some works in the field of Cal/Val of this sensor have been reported by Mattar et al (2015) and Barrientos et al (2016), using surface reflectance measurements and the cross-calibration technique based on simultaneous nadir observations (SNO's), respectively.…”

First in-Flight Radiometric Calibration of MUX and WFI on-Board CBERS-4

“…The ASR generates a digital output signal which is linearly proportional to the solar irradiance. This can be modeled according to the Beer Law [26][27][28].…”

“…Assuming that total optical depth remains constant over the range of air masses for which measurements are performed, a Langley plot (linearization of Beer's law) will yield a set of data points distributed along a straight line with slope equal to the total optical depth and intercept equal the natural logarithm of the ASR calibration constant [26][27][28].…”

“…Therefore, the spectral range centered approximately at 940 nm was used to estimate the water vapor atmospheric content. Columnar water vapor was determined using a modified-Langley approach [28][29][30].…”

Radiometric Cross-Calibration of the Chilean Satellite FASat-C Using RapidEye and EO-1 Hyperion Data and a Simultaneous Nadir Overpass Approach

“…As far as Chile is concerned, it is our intention to obtain and assign additional resources to the exploration, characterization and use of Cal/Val sites, with emphasis on sites where field campaigns and inter-comparison studies with other satellite programs have already been performed [98][99][100][101][102][103][104].…”