Sowing Geometry of Intertilled Crops

Завражнов, А. А.; Завражнов, А. И.; Zemlyanoj, A. A.; Lantsev, V. Yu.; Akishin, D. V.; Ibraev, A. S.; Yakushev, A. V.

doi:10.3103/s106836742202015x

Cited by 2 publications

(2 citation statements)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A wide range of available bulk powdered and fine-grained feed additives allows specialists to make balanced feed mixes for feeding livestock, depending on the content, productivity and other factors. Feed additives are recommended to be included in the composition the feed mixture in the amount of 10-300 g for each livestock [1]. With such a relatively small amount of feed additives, the problem arises of ensuring the mixing efficiency and uniformity their distribution in the volume the feed mixture.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Drum dispenser of feed additives

Eshdavlatov,

Mamatov,

Eshdalatov

et al. 2023

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

The purpose the study is to determine the performance justification design parameters and operating mode of a continuous drum dispenser. To dispense bulk powdery and fine-grained feed additives in small quantities into the feed mixture, a continuous drum dispenser is proposed, which consists of a hopper, an inlet and outlet neck, a rotor housing and sectors. The inlet neck of the dispenser is located on the left side the dispenser shaft, and the outlet neck is on the right side. Theoretical studies were carried out using the basic provisions of technical mechanics. The experiments were carried out on a specially manufactured installation. As a result of the research, the following design parameters and operating mode of a continuous drum dispenser were established, providing productivity within Q=10-137kg/h: the number of sectors in the rotor is 6, the number of rotations of the rotor is 40 r/min, the radius of the circumference outer arc of the sector is 39 mm, the radius of circle forming the inner arc sector is 29 mm.

show abstract

Section: Introductionmentioning

confidence: 99%

“…A. Zavrazhnov [1], N. Frolov [2], Ju. Kazakov [3], F. Mamatov have been dealing with the problem of dosing high-value feeds in different years [4 -10], E. Avakimjanc [11], S. Melnikov [12], F. Maiviatov [13,14], Yu.…”

Section: Introductionmentioning

confidence: 99%