Some Technical Aspects of the Rheological Properties of High Concentration Fine Suspensions to Avoid Environmental Disasters

Abstract

The behavior of slurries and suspensions made by mixing solid particles and liquids is very important for various industrial applications. The latest accidental failure events at tailings facilities (Kolontár, Baia Mare) have focused public interest into this field. Nowadays, environmental practice is turning to use dry deposition techniques or at least as high concentration slurries or pastes as possible, to avoid large spills in case of an accidental failure of an embankment. High concentration slurries are becoming widely accepted in many environmentally related operations such as underground backfilling or simple tailings deposition. However, the hydraulic transport of pastes or high density slurries requires higher energy input via pumps, and, in addition, the energy requirement or pressure loss calculation methods are also different because the rheology of pastes differs from that of dilute slurries. At the University of Miskolc, Institute of Raw Materials Preparation and Environmental Processing, Miskolc, Hungary, this topic has been studied for many decades. The fine suspension – coarse mixture flow model was introduced, and it has been determined that the flow behavior of fine suspensions made of solid particles smaller than a limit particle size can be measured and interpreted in almost the same way as for single phase clear liquids. Based on these measured rheological parameters of fine suspensions, the frictional energy loss can be calculated. The aim of this paper is to give a summary and data base about the rheological behavior of different industrial materials based on pilot scale hydraulic loop measurements. An Anton-Paar rotational viscometer and a tube viscometer with three measuring pipe sections,– developed by our institute – were used for testing. The results of measurements of various granular materials, such as sands, fly ashes, perlite, tailings and red mud are presented in connection with environmental applications. Based on these results, empirical relationships are presented, where the parameters are determined by simple function fitting into the data of measurements carried out at discrete concentration values. The rheology of fine suspensions of any concentration up to the measured maximum can be calculated by these relationships.

Mechanical activation of power station fl y ash by grinding – A review

“…However, it is well known that significant amount (about 50%) of the by-products is landfilled [1], causing a serious environmental risk [44]. In this way the composition of these materials change due to weathering conditions resulted in a lower reactivity.…”

“…The Blaine method is based on air permeability of material bed, and it is widely used in the cement industry [45]. The BET method represents the inner pores (micro-and mezo pores) of the particles as well, based on gas adsorption on the surface of the investigated solid material.…”

Probabilistic Analysis of Floods from Tailings Dam Failures: A Method to Analyze the Impact of Rheological Parameters on the HEC-RAS Bingham and Herschel-Bulkley Models

“…To conduct the sensitivity tests in this study, parameter value ranges for the equations were determined based on an extensive literature review related to mining tailings [2,[7][8][9][10]14,27,37,38,[47][48][49][50][51][52][53]. The tailings studied by these authors included coal, copper, iron, lithium, base metal, nickel, gold, pyrophyllite, uranium, and zinc, as well as synthetic and theoretical materials, and the obtained values are listed in Appendix A.…”

“…Rheology investigated the flow and deformation behavior of fluids in different contexts [4,5]. Rheological parameters are obtained and analyzed through rheological tests conducted on various materials over time [6][7][8]. Several factors can influence the variability of rheological parameters, including shear rate, solid concentration, pH, and temperature [9].…”

Automated batch settling column with vibrated rods and evaluation protocol for living waters mud thickening

“…By this software the first (velocity) and second (acceleration) derivatives of the spline smoothed settling curve (height of the settling mud as function of time) and the main technical parameters for thickener design can be determined. Theoretical terminal settling velocity calculations were carried out by methods developed earlier [8,9,10]. The aim of the carried out research work was to reveal consequences necessary for the rod-lamella thickener development.…”