Solid‐state hydrolysis of postconsumer polyethylene terephthalate after plasma treatment

Abstract

Plasma treatments were applied on the surface of postconsumer polyethylene terephthalate (PET) bottles to increase their wettability and hasten the subsequent hydrolysis process. Sixty-four treatments were tested by varying plasma composition (oxygen and air), power (25-130 W), pressure (50-200 mTorr), and time (1 and 5 min). The best treatment was the one applied in air plasma at 130 W and 50 mTorr for 5 min, as it provided the lowest contact angle, 9.4 . Samples of PET before and after the optimized plasma condition were subjected to hydrolysis at 205 C. Although the treatment changed only a thin surface layer, its influence was evident up to relatively high conversion rates, as the treated samples presented more than 40% higher conversion rates than the untreated ones after 2 h of reaction. Infrared spectroscopy showed that the terephthalic acid obtained from 99% of depolymerization was similar to the commercial product used in PET synthesis.

Wettability and surface microstructure of polyamide 6 coated with SiOXCYHZ films

“…Commercial polyamide 6 plates (2.0 mm × 1.5 mm) were initially cleaned in ultrasonic baths, as described by Mancini et al [24], and positioned on the lower electrode of the plasma reactor schematically shown in Fig. 2 [14].…”

Innovative low temperature plasma approach for deposition of alumina films

“…The substrates were first cleaned in ultrasonic baths, according to the procedures described in a previous work 13 . The cleaned samples were attached to the uppermost electrode of the plasma system using adhesive tape and submitted to a plasma ablation procedure to further clean and activate the substrate surfaces.…”

Surface properties and corrosion resistance of SF6 plasma‐treated polyester‐based thermoplastic elastomer

“…Commercial COPE (DSM Arnitel EM400) samples, produced by molding injection and cut into 10 mm × 20 mm pieces, were first washed in ultrasonic baths, as described fully elsewhere . After being dried in a hot air flow, samples were placed in the plasma processing system, described in detail by Rangel et al…”