Sintering of Alumina by Microwave (2.45GHz) Heating based on Isothermal Barrier.

Dense alumina and Ni-Zn-Cu ferrites, and porous hydroxyapatite (HAP) have been fabricated using a fused deposition modeling (FDM) type 3D printer, so-called "Additive Manufacturing (AM)". Green bodies of the former two were consisted of the laminated layer filaments from ceramics/resin = 60/40 vol% kneaded bodies to obtain dense ceramics. On the other hand, the latter was composed of 50/50 or 55/45 vol% filaments for porous scaffold. Binder-out process was performed in air with the selected temperature range/heating rate and final 673~723 K for 1.08~18.0 • 10 5 s, corresponding to each material. Hot Isostatic Pressed fine grained alumina after microwave sintering with an apparent relative density of 94%, substantially more than 98% by looking at the microstructure, revealed a bending strength of 562 MPa. Permeability µ of dense Ni-Zn-Cu ferrite sintered in air was nearly the same as that of conventional one; at low frequencies µ of "AM" ferrite surpassed the latter. Porous two kinds of HAP ceramics were fabricated from the different calcining temperatures 1223 and 1248 K, and biotested in terms of the cell culture at 310 K for 8.64 and 25.9 • 10 4 s. The cells on HAP produced from 1223 K calcined grew twofold in comparison with those of control glass. KEY WORDSFDM, 3D printer, alumina, Ni-Zn-Cu ferrite, hydroxyapatite

show abstract

scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.

Contact Info

customersupport@researchsolutions.com

10624 S. Eastern Ave., Ste. A-614

Henderson, NV 89052, USA

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Blog Terms and Conditions API Terms Privacy Policy Contact Cookie Preferences Do Not Sell or Share My Personal Information

Made with 💙 for researchers

Part of the Research Solutions Family.

Sintering of Alumina by Microwave (2.45GHz) Heating based on Isothermal Barrier.

Cited by 2 publications

References 0 publications

A review on combustion synthesis intensification by means of microwave energy

A review on combustion synthesis intensification by means of microwave energy

Fabrication of Ceramics Using a Fused Deposition Modeling (FDM) Type 3D Printer - High Density Alumina and Ni-Zn-Cu Ferrites, and a Hydroxyapatite (HAP) Scaffold -

Contact Info

Product

Resources

About