Single Stage Low Noise Inductor-Less TIA for RF Over Fiber Communication

Abstract

This paper presents design, mathematical analysis, and measurement of low noise singlestage transimpedance amplifier (TIA) with scalable bandwidth using 130 nm bipolar complementary metaloxide-semiconductor (BiCMOS) silicon-germanium (SiGe) process. Common-emitter (CE) shunt-shunt feedback topology with active inductor peaking has been used in the design for improving noise, gain and driving capability of TIA by decreasing the input and output impedance, respectively. The use of active inductive peaking in CE shunt-shunt feedback topology has resulted in a new TIA configuration with better performance. The circuit has been optimized for low noise performance by adopting the proposed design technique. Validity of the mathematical analysis and design for the proposed TIA has been established with the help of simulations as well as measurement results. The measurement results of Ku-band TIA (10 MHz to 14 GHz) have demonstrated a transimpedance gain of 53.2 dBΩ, input-referred current noise of 16.8 pA/ √Hz with power consumption of 9.8 mW . The design architecture is adaptable for higher frequency bands, which has been demonstrated by designing another TIA covering K-and Ka-bands (10 MHz to 35 GHz) with transimpedance gain of 33.4 dBΩ, input-referred current noise of 29.4 pA/ √Hz with power consumption of 28.1 mW in the post-layout simulation results, and occupies same chip area as that of 14 GHz, i.e., 0.1 × 0.21 mm 2 INDEX TERMS BiCMOS, CE topology, inductive peaking, low noise, silicon-photonics, TIA

An Inductorless Optical Receiver Front-End Employing a High Gain-BW Product Differential Transimpedance Amplifier in 16-nm FinFET Process

“…A vertical eye-opening of 20 mV with a width of 0.1 UI at a BER of 1E-6 is achieved. Finally, Table III compares performance of the proposed TIA with the state-of-the-art inductorless TIAs [35][36][37][38]. Reference [10] employs inductors and transformers to improve the GBP without sacrificing the power consumption.…”