Simultaneous determination of triclosan，triclocarban and &amp;lt;italic&amp;gt;p&amp;lt;/italic&amp;gt;-chloro-&amp;lt;italic&amp;gt;m&amp;lt;/italic&amp;gt;-xylenol in disinfectant，personal care products and oiltment by nonaqueous capillary electrophoresis

Jiang, Ruoke; Ding, Xin

doi:10.3724/sp.j.1123.2022.06016

Cited by 2 publications

(1 citation statement)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In order to ensure quantitative accuracy and precision, the type and content of the solvent in the sample buffer were thoroughly investigated. The solvent in the sample buffer plays a crucial role in the analysis [34]. To determine the optimal solvent type and its content in the sample buffer, various combinations were tested while keeping the other CE conditions constant, as mentioned in Section 2.3.…”

Section: The Choice Of Solvent and Its Contentmentioning

confidence: 99%

Analysis of Two Single and Three Double Long-Chain Quaternary Ammonium Compounds via Non-Aqueous Capillary Electrophoresis with Indirect Ultraviolet Detection

Yao

Jiang

et al. 2023

Separations

Self Cite

View full text Add to dashboard Cite

A novel method utilizing non-aqueous capillary electrophoresis (NACE) with indirect ultraviolet detection (IUD) has been developed for the analysis of five quaternary ammonium compounds (QACs). The QACs analyzed in this study include dodecyl trimethyl ammonium bromide, tetradecyl trimethyl ammonium bromide, dioctyl dimethyl ammonium chloride, octyldecyl dimethyl ammonium chloride and didecyl dimethy ammonium bromide. The separation process was carried out on an uncoated fused quartz capillary with a total length of 50.2 cm (effective length 40.0 cm) and a diameter of 50 μm. The separation buffer consisted of a mixture of MeOH/ACN (90:10, v/v) containing 2 mmol/L sodium acetate, 2 mmol/L trifluoroacetic acid (TFA) and 16 mmol/L dodecyl dimethyl benzyl ammonium chloride. The sample buffer utilized a mixture of MeOH/ACN (20:80, v/v) containing 2 mmol/L TFA. During analysis, a separation voltage of 7 kV was applied, resulting in a current of approximately 2.3 μA. The detection wavelength was set at 214 nm to ensure optimal sensitivity. Under optimal conditions, the method exhibited excellent performance characteristics, with a limit of detection of 0.5 mg/L and a limit of quantitation of 5.0 mg/L for the five QACs. Linear calibration curves were obtained in a concentration range of 5.0 to 100.0 mg/L, with correlation coefficients exceeding 0.999 for all compounds. The recoveries of the five QACs ranged from 92.3% to 114.7%, with relative standard deviations below 7.4%. To assess the applicability of the NACE-IUD method, 17 commercially available samples were successfully analyzed. The results confirmed the suitability of the method for accurate determination of the five QACs in disinfectant products. Notably, this method offers an environmentally friendly approach for the analysis of these QACs.

show abstract

Section: The Choice Of Solvent and Its Contentmentioning

confidence: 99%