Simulation of Binder Infiltration in Additive Manufacturing of Sand Molds

Abstract

This article proposes a CFD approach to simulate binder infiltration in 3D printing of sand molds using OpenFOAM facilitating the identification of suitable levers for application‐specific material and process developments. A method for randomly generating powder bulks of designated powder size distributions (PSD) and procedures for automated analysis of the infiltration profile and volume are introduced. Simulation is utilized to investigate binder infiltration using different droplet spacings, representing different printheads’ resolutions. The apparent particle size at the exact location of the droplets’ impact, the droplets’ landing position in relation to the respective surface topography, and thus the statistical appearance of particle formations appear to be influencing the infiltration profile. High‐speed camera observations show the plausibility of the predicted infiltration kinetics. An exemplary use case compares the predicted infiltration profiles to the compressive strength of specimens printed from silica sand with low binder contents. Simulation predicts an average infiltration of 250 µm that presumably achieves reliable bonding for layer thicknesses up to 365 µm. A decrease in strength with increasing layer thickness at constant binder contents can be found in the experiment – at layer thicknesses above 350 µm, only minor strengths are achieved.This article is protected by copyright. All rights reserved.