Simulation mathematical model of the pipe reduction process

Vydrin, A. V.; Akhmerov, D. A.; Khramkov, E. V.

doi:10.17580/chm.2021.10.10

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…However, this process has its feature: thickened end parts are formed during pipe tension reduction. It is caused by absence of longitudinal stresses during reduction of these end parts, unlike the main parts of pipes [2][3][4][5][6]. Additionally, their forming is conducted in the conditions of filling and release of deformation area.…”

Section: Introductionmentioning

confidence: 99%

Investigation of forming of end parts in pipe tension reduction using QForm program

Akhmerov¹,

Vydrin²,

Khramkov³

et al. 2022

cisisr

View full text Add to dashboard Cite

The paper deals with issues of longitudinal stresses during pipe rolling pipes on a three-roll stretching and reduction mill. Opportunities and problems in pipe reduction under tension are described. A research program aimed on reduction and evaluation of all input parameters that affect the parameters of the end parts of pipes based has been developed on the finite element model (FEM) base. Computer study on the FEM basis of stretching and reduction rolling of pipes using the Qform-3D program was carried out. When setting up the experiment using the FEM, the relative variation of the pipe wall thickness at the end parts of the pipe was chosen as the parameter for examination. Reduction of the pipe in its diameter in the pass, ovality of the pipe, geometric parameters of the initial pipe, front and rear tension of the pipe and friction coefficient were the main factors that determine the studying values. Geometric parameters of the end parts of the simulated pipe were measured after modeling. A statistical analysis of the results of a computational experiment of data on variation of pipe wall thickness was carried out. Regression dependence was built using the MATLAB program, and the most significant factors were selected according to the level of their importance. The model that describes the behavior of wall thickness during rolling in a stand of a stretching and reduction mill has been constructed.

show abstract

Section: Introductionmentioning

confidence: 99%