Simulating the electrical characteristics of a photovoltaic cell based on a single-diode equivalent circuit model

Afghan, Syeda Adila; Almusawi, Husam; Husi, Géza

doi:10.1051/matecconf/201712603002

Cited by 10 publications

(8 citation statements)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Performing mathematical equation modeling analysis on photovoltaic cell, so that the results achieved are more accurate than direct measurements on a photovoltaic cell [6][7]. The requirements that must be possessed in design photovoltaic cell are mandatory to use the STC (Standard Test Condition), where the requirements that must be met are a temperature of 25°C and solar radiation of 1.000 W/m 2 [8].…”

Section: Research Methods 21 Photovoltaic Cell Modelmentioning

confidence: 99%

“…In the reference paper [8], the author state that it is very important to obtain the five parameters of the photovoltaic cell equivalent circuit. There are five parameters owned by the photovoltaic cell equivalent circuit [11].…”

Section: Figure 3 Photovoltaic Cell I-v Curve Characteristicsmentioning

confidence: 99%

Section: Micro Photovoltaic Cell Curve Simulationmentioning

confidence: 99%

“…In Figure 8, the graph of micro photovoltaic cell I-V curve is the result obtained when carried out tests in accordance with the Standard Test Condition(STC) where the temperature value used is 25°C and the irradiance value used is 1000 W/m 2 [8]. Based on Figure 8 [8]. Based on Figure 9, the P-V curve, the x-axis is the parameter value of Voc with a value range of 0mV to 200mV, while the y-axis is the parameter value of the power maximum point (Pmp) with a value range of 0µW to 1,6µW.…”

Section: Micro Photovoltaic Cell Curve Simulationmentioning

confidence: 99%

See 3 more Smart Citations

Design and Simulation of Low Power and Voltage Micro Photovoltaic Cell for Mobile Devices

Rullah

Harahap

Wibowo

et al. 2022

KINETIK

View full text Add to dashboard Cite

In this study, designed and simulated a micro photovoltaic cell circuit which is part of smartphone battery charging system sensor. Problem discussed in this paper was that smartphone are still charging battery from PLN through a wall outlet, but smartphone would be better off if it had other charging alternatives, such as being able to charge anywhere or mobile. This paper proposed used photovoltaic cell that can convert sunlight into electricity and it can charge the battery on a smartphone. Photovoltaic cell were integrated with smartphone batteries in photovoltaic IC to form a battery charging system that can charge smartphone. The design of the micro photovoltaic cell sensor section is based on from the references paper. Micro photovoltaic cell was design by modifying the resistor value in the micro photovoltaic cell circuit, so the output low voltage and power be able to charge the smartphone battery. Designed and simulated micro photovoltaic cell circuits will be carried out using LTSpice. The results that achived in this research, when shunt resistance value was configure negative, the voltage value around 200mV, the power value around 1,48µW. When the shunt resistance value was configure positive the voltage value around 199mV, the power value around 1,44µW. Analysis was carried out by comparing voltage values obtained in this study with previous studies. In this study, a smaller voltage value was obtained by modifying the resistor value in the micro photovoltaic cell circuit. The circuit design will later be implemented in 0.35µm CMOS technology.

show abstract

Section: Research Methods 21 Photovoltaic Cell Modelmentioning

confidence: 99%

Section: Figure 3 Photovoltaic Cell I-v Curve Characteristicsmentioning

confidence: 99%

Section: Micro Photovoltaic Cell Curve Simulationmentioning

confidence: 99%

Section: Micro Photovoltaic Cell Curve Simulationmentioning

confidence: 99%

See 2 more Smart Citations

Design and Simulation of Low Power and Voltage Micro Photovoltaic Cell for Mobile Devices

Rullah

Harahap

Wibowo

et al. 2022

KINETIK

View full text Add to dashboard Cite

show abstract

“…A solar cell should be operated to get a maximum power obtain from short circuit current and open circuit voltage Afghan et al (2017).…”

mentioning

confidence: 99%

A Review on MPPT Algorithms for Solar Pv Systems

Senthilkumar

Mohan

Deepa

et al. 2023

Int. J. Res. Granthaalayah

View full text Add to dashboard Cite

In past few decades, solar energy plays a vital role in energy production among the different renewable energy resources. In shaded/unshaded photovoltaic (PV) systems, tracking of maximum power under different environmental conditions is provided by maximum power point tracking (MPPT). In recent years many works available on different types of MPPT techniques to track maximum power from PV systems with own pros and cons. This article comprehensively reviews the different traditional methods like perturb and observation (P&O), open circuit voltage (OCV), short circuit current (SCC), hill climbing (HC), incremental conductance (IC). Also recall the advanced MPPT techniques like particle swarm optimization (PSO), grey wolf optimization (GWO), cuckoo search (CS), artificial neural networks (ANN), fuzzy logic controller (FLC) available in literature. This review is conducted based on implementation, accuracy, tracking speed, cost, merits, and demerits of each technique. Traditional MPPT methods can’t able to track global maximum power point under partial shaded conditions and exhibits less efficiency when compared with advanced soft computing methods. Hybrid methods provide good efficiency and performance than traditional and advanced methods. Authors powerfully confirm that this article offers convenient information’s to enthusiastic engineers and new researchers those who are all working in solar PV systems.

show abstract