Simpson’s 3/8–based method stability analysis for milling processes

Liu, Chunjing; Tang, Dunbing; Li, Shengfeng; Ding, Guohua

doi:10.1007/s00170-021-06732-0

Cited by 2 publications

(3 citation statements)

References 33 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In this section, SDM [ 10 ] and SEM [ 16 ] are compared. For objective comparison, the CCM, SDM, and SEM share the same parameters and machining conditions.…”

Section: Composite Cotes-based Methodsmentioning

confidence: 99%

“…The Lagrange polynomial denoted by P L ( x ) [ 16 , 24 ] can be used to approximate f ( x ) as follows:

where

…”

Section: Simpson’s 3/8-based Methodsmentioning

confidence: 99%

“…Qin et al [ 15 ] approximated the state terms of the delay differential equation with the Chebyshev wavelets of the second kind. Moreover, Liu et al [ 16 ] combined the numerical solution of the delay differential equation with the Simpson formula to predict milling stability (SEM), which was only suitable for large radial immersion. However, the aforementioned numerical methods cannot simultaneously guarantee fast convergence speed and high computational efficiency.…”

Section: Introductionmentioning

confidence: 99%

See 2 more Smart Citations

Predicting Milling Stability Based on Composite Cotes-Based and Simpson’s 3/8-Based Methods

Ren

Zheng

2022

Micromachines

View full text Add to dashboard Cite

Avoiding chatter in milling processes is critical for obtaining machined parts with high surface quality. In this paper, we propose two methods for predicting the milling stability based on the composite Cotes and Simpson’s 3/8 formulas. First, a time-delay differential equation is established, wherein the regenerative effects are considered. Subsequently, it is discretized into a series of integral equations. Based on these integral equations, a transition matrix is determined using the composite Cotes formula. Finally, the system stability is analyzed according to the Floquet theory to obtain the milling stability lobe diagrams. The simulation results demonstrate that for the single degree of freedom (single-DOF) model, the convergence speed of the composite Cotes-based method is higher than that of the semi-discrete method and the Simpson’s equation method. In addition, the composite Cotes-based method demonstrates high computational efficiency. Moreover, to further improve the convergence speed, a second method based on the Simpson’s 3/8 formula is proposed. The simulation results show that the Simpson’s 3/8-based method has the fastest convergence speed when the radial immersion ratio is large; for the two degrees of freedom (two-DOF) model, it performs better in terms of calculation accuracy and efficiency.

show abstract

“…In this section, SDM [ 10 ] and SEM [ 16 ] are compared. For objective comparison, the CCM, SDM, and SEM share the same parameters and machining conditions.…”

Section: Composite Cotes-based Methodsmentioning

confidence: 99%

“…The Lagrange polynomial denoted by P L ( x ) [ 16 , 24 ] can be used to approximate f ( x ) as follows:

where

…”

Section: Simpson’s 3/8-based Methodsmentioning

confidence: 99%