Shock response of single crystal and nanocrystalline pentaerythritol tetranitrate: Implications to hotspot formation in energetic materials

Abstract

We investigate shock response of single crystal and nanocrystalline pentaerythritol tetranitrate (PETN) with a coarse-grained model and molecular dynamics simulations, as regards mechanical hotspot formation in the absence or presence of grain boundaries (GBs). Single crystals with different orientations, and columnar nanocrystalline PETN with regular hexagonal, irregular hexagonal, and random GB patterns, are subjected to shock loading at different shock strengths. In single crystals, shock-induced plasticity is consistent with resolved shear stress calculations and the steric hindrance model, and this deformation leads to local heating. For regular-shaped hexagonal columnar nanocrystalline PETN, different misorientation angles lead to activation of different/same slip systems, different deformation in individual grains and as a whole, different GB friction, different temperature distributions, and then, different hotspot characteristics. Compared to their regular-shaped hexagonal counterpart, nanocrystalline PETN with irregular hexagonal GB pattern and that with random GBs, show deformation and hotspot features specific to their GBs. Driven by stress concentration, hotspot formation is directly related to GB friction and GB-initiated crystal plasticity, and the exact deformation is dictated by grain orientations and resolved shear stresses. GB friction alone can induce hotspots, but the hotspot temperature can be enhanced if it is coupled with GB-initiated crystal plasticity, and the slip of GB atoms has components out of the GB plane. The magnitude of shearing can correlate well with temperature, but the slip direction of GB atoms relative to GBs may play a critical role. Wave propagation through varying microstructure may also induce differences in stress states (e.g., stress concentrations) and loading rates, and thus, local temperature rise. GBrelated friction and plasticity induce local heating or mechanical hotspots, which could be precursors to chemical hotspot formation related to initiation in energetic materials, in the absence of other, likely more effective, means for hotspot formation such as void collapse. © 2013 AIP Publishing LLC. [http://dx

Ultrasonic hammer produces hot spots in solids

“…We believe that it is the interfacial delamination between the solid inclusion and the polymer that serves as nucleation sites for ultrasonic hot spots through frictional heating; local frictional heating has previously been speculated to occur under shockwave impact 13,19,30,31 . As shown in Fig.…”

Mode-Selective Vibrational Energy Transfer Dynamics in 1,3,5-Trinitroperhydro-1,3,5-Triazine (RDX) Thin Films

“…The observed mode-selectivity in these longest dynamics, coupled with DFT simulations showing compression orientation-dependent peak shifts, may provide key clues to the observed crystallographic orientation dependence on shock sensitivity. 92 Finally, these MD results under static compression suggest that, following shock compression, excited phonon relaxation times will be substantially longer than have been previously assumed. 18 Such a persistent, non-equilibrium phonon distribution would have more opportunity to excite higher frequency, chemically reactive coordinates through either the multiphonon up-pumping 1,2 or direct coupling 4,27 pathways.…”

Interpreting Experimental Results from Shock Impacts on Single Crystal PETN in the Context of Continuum Models

“…However, interface velocimetry measurements alone cannot tell us which slip systems might be active for impacts on orientations with a high Hugoniot elastic limit. Several groups have proposed additional slip systems or deformation mechanisms that might be activated under shock conditions . Furthermore, X‐ray topographic studies have identified dislocations with Burgers vectors other than (111), but whether these dislocations are glissile and on which planes they might glide is currently unknown .…”