Shape Memory Alloy (SMA) Actuator With Embedded Liquid Metal Curvature Sensor for Closed-Loop Control

Abstract

We introduce a soft robot actuator composed of a pre-stressed elastomer film embedded with shape memory alloy (SMA) and a liquid metal (LM) curvature sensor. SMA-based actuators are commonly used as electrically-powered limbs to enable walking, crawling, and swimming of soft robots. However, they are susceptible to overheating and long-term degradation if they are electrically stimulated before they have time to mechanically recover from their previous activation cycle. Here, we address this by embedding the soft actuator with a capacitive LM sensor capable of measuring bending curvature. The soft sensor is thin and elastic and can track curvature changes without significantly altering the natural mechanical properties of the soft actuator. We show that the sensor can be incorporated into a closed-loop “bang-bang” controller to ensure that the actuator fully relaxes to its natural curvature before the next activation cycle. In this way, the activation frequency of the actuator can be dynamically adapted for continuous, cyclic actuation. Moreover, in the special case of slower, low power actuation, we can use the embedded curvature sensor as feedback for achieving partial actuation and limiting the amount of curvature change.

Polydopamine Shell as a Ga3+ Reservoir for Triggering Gallium–Indium Phase Separation in Eutectic Gallium–Indium Nanoalloys

“…Nanometallurgy offers great opportunities for developing intelligent systems. − In the field of nanometallurgy, gallium (Ga)-based alloys have recently attracted significant attention as they extend access to the liquid state of metals at room or near room temperature. − For liquid metal alloys of Ga, a certain mixed ratio of other metals with Ga leads to “eutectic” systems that have the lowest melting temperature due to the increased entropy . A famous eutectic alloy of Ga is its mixture with indium (In), which is called EGaIn, consisting of 75 wt % Ga and 25 wt % In that offers a low melting temperature of ∼15.7 °C .…”

Strong, Shape-Memory Lignocellulosic Aerogel via Wood Cell Wall Nanoscale Reassembly

“…A similar shape-memory phenomenon could be achieved even with ambient drying followed by exposure to water; see Figure S2. The shape memory property makes the aerogel attractive as a sensor. , The processing and properties apply to large samples. Figure e shows a larger hydrogel (length, 160 mm; width, 40 mm; thickness, 2 mm) which could be wrapped around a glass cylinder and subsequently dried to obtain a helix-shaped aerogel.…”

4D printing of soft orthoses for tremor suppression

“…Shape memory polymers (SMPs) have significantly contributed to the 4D printing of soft wearable actuators [115], yielding a high recovery rate of 96% [116]. In addition, the integration of SMA and SMP with multi-material printing [117] has resulted in a soft robotic hand, which was reported to work at 0.125 Hz without active cooling and capable of handling heavy objects up to 133 g [118]. Furthermore, SMAs may be more efficient and versatile in soft orthoses embedded with curvature sensors [119] and smart soft composites (SSC) [120].…”