Shape and tension distribution of the active canine diaphragm

Abstract

Both diaphragm shape and tension contribute to transdiaphragmatic pressure, but of the three variables, tension is most difficult to measure. We measured transdiaphragmatic pressure and the global shape of the in vivo canine diaphragm and used principles of mechanics to compute the tension distribution. Our hypotheses were that 1) tension in the active diaphragm is nonuniform with greater tension in the central tendon than in the muscular regions; 2) maximum tension is essentially oriented in the muscle fiber direction, whereas minimum tension is orthogonal to the fiber direction; and 3) during submaximal activation change in the in vivo global shape is small. Metallic markers, each 2 mm in length, were implanted surgically on the peritoneal surface of the diaphragm at 1.5-to 2.0-cm intervals along the muscle bundles at the midline, ventral, middle, and dorsal regions of the left costal diaphragm and along a muscle bundle of the crural diaphragm. Postsurgery, a biplane videofluoroscopic system was used to determine the in vivo threedimensional coordinates of the markers at end expiration and end inspiration during quiet breathing as well as at end-inspiratory efforts against an occluded airway at lung volumes of functional residual capacity and at one-third maximum inspiratory capacity increments in volume to total lung capacity. A surface was fit to the marker locations using a two-dimensional spline algorithm. Diaphragm surface was modeled as a pressurized membrane, and tension distribution in the active diaphragm was computed using the ANSYS finite element program. We showed that the peak of the diaphragm dome was closer to the ventral surface than to the dorsal surface and that there was a depression or valley in the crural region. In the supine position, during inspiratory efforts, the caudal displacement of the dorsal region of the diaphragm was greater than that of the dome, and the valley along the crural diaphragm was accentuated. In contrast, at lower lung volumes in the prone posture, the caudal displacement of the dome was greater than that of the crural region. At end of inspiration, transdiaphragmatic pressure was ϳ6.5 cmH2O, and tensions were nonuniform in the diaphragm. Maximum principal stress 1 of central tendon was found to be greater than 1 of the costal region, and that was greater than 1 of the crural region, with values of 14 -34, 14 -29, and 4 -14 g/cm, respectively. The corresponding data of the minimum principal stress 2 were 9 -18, 3-9, and 0 -1.5 g/cm, respectively. Maximum principal tension was approximately parallel to the muscle fibers, whereas minimum tension was essentially orthogonal to the longitudinal direction of the muscle fibers. In the muscular region, 1 was ϳ3-fold 2, whereas in the central tendon, 1 was only ϳ1.5-fold 2.respiratory muscle mechanics; chest wall mechanics; finite element modeling; membrane mechanics THE SHAPE OF THE DIAPHRAGM is vital for converting muscle tension into transdiaphragmatic pressure (P di ) and muscle shortening into volume displacement. It i...

Tissue contribution to the mechanical features of diaphragmatic initial lymphatics

“…As suggested by data of Fig. 6 and , E t was mildly higher in ventral compared to dorsal regions of the diaphragm, as expected from the anatomically higher percentage of stiffer tendineous fibres in the ventral than in the dorsal diaphragm (Boriek et al 2005). These regional differences might be important in terms of lymphatic function.…”

“…The tension in the wall of the mesenteric lymphatics during smooth muscle cells contraction increases by about 3 times (Zhang et al 2007) with no apparent change in compliance. Vice versa , since diaphragmatic tissue elastance greatly increases (up to ∼80 MPa) during inspiratory contraction (Boriek et al 2005), deep diaphragmatic lymphatics might actually become even stiffer than in relaxed diaphragm.…”

Chronic Intrinsic Transient Tracheal Occlusion Elicits Diaphragmatic Muscle Fiber Remodeling in Conscious Rodents

“…We also found modest yet significant CSA differences in the crural region that could be related to the additional postural [42] and lower esophageal sphincter [43] functions of the crural diaphragm. Rat motor unit activity appears uniform in the crural and costal segments with inspiration and non-ventilatory behaviors [44], [45], and injurious mechanical loads typically induce greater rat costal than crural diaphragmatic remodeling [21], [30].…”

Mechanical Properties of Respiratory Muscles

“…Conversely, anisotropic materials have mechanical properties that are non-uniform; strain varies with the direction of force. The central tendon is nearly isotropic (47, 49, 196) and inextensible (47). The diaphragm and internal abdominal muscles are anisotropic.…”