Separation of common and differential mode conducted emission: Power combiner/splitters

Abstract

Abstract-A conducted emission measurement contains a common and a differential mode component. Accurate separation of these two components is critical, when designing the input filter of a switch mode power supply. Many techniques exists for performing such separation. Some authors suggested the use of wideband transformers, while other prefer current probes. In this paper the use of commercial power splitters/combiners as noise separators are considered. The performance of the noise separators are analyzed and validated based on scattering parameters (S-parameters). Impedance and rejection ratios (common and differential mode) are shown. The results based on S-parameters are used to propose a complete noise separator design. This separator is verified through experimental measurements. Finally an example on how to use the separator, when measuring conducted noise is given.