Sensors for built-in alternate RF test

Abstract

ISBN 978-1-4244-5834-9International audienceThe paper discusses a variety of sensors to enable a built-in test in RF devices. The list of sensors includes dummy circuits, process control monitors, DC probes, an envelope detector, and a current sensor. Dummy circuits and process control monitors are simple circuits that do not tap into the signal path of the RF device. Instead, they monitor the device by virtue of being subject to the same process variations. Their outputs form an alternative measurement pattern which can be mapped to the performances of the device using a typical alternate test flow. The rest of the sensors are physically connected to the RF device, thus they can detect random catastrophic defects within it and, as an auxiliary benefit, they can improve the accuracy in predicting its performances. The degradation that these sensors incur is carefully assessed and the RF device is co-designed with them to correct for the losses. The operation and test efficiency of the sensors is demonstrated for the case of an RF LNA using post-layout simulations

A self-tuning architecture for buck converters based on alternative test

“…Note that the logic levels of the LFSRs are always consistent with that of buck converter's internal logic. Optimization of the LFSR structure is performed via genetic optimization similar to that discussed in [5][6][18][19][20][21] and produces an LFSR that generates perturbations in such a way that the response of the converter to the applied perturbations are maximally correlated with the specifications of the converter under multi-parameter statistically representative process variations.…”

“…In this context, techniques such as self-learning based adaptation [12][13], power-conscious tuning [14] and system level testing and tuning [15][16][17] concepts have been developed. Although a self-tuning approach based on alternative built-in self-test for RF devices has been developed in the past to reduce testing cost and testing time [18][19][20][21], the work reported in this paper develops, for the first time, a testing and self-tuning methodology that avoids the hazards (voltage spikes) associated with standard testing procedures while providing guarantees for the same.…”

Post-deployment trust evaluation in wireless cryptographic ICs

“…The transistor-level structure of this current sensor can be seen in the blow-out part of Figure 2. The output of the BICS is a high frequency signal which we convert to a DC voltage through a CMOS envelope detector [10]. Both the current sensor and envelope detector are CMOS designs so that they are compatible with other parts of the circuit.…”

Adaptive Logical Control of RF LNA Performances for Efficient Energy Consumption

“…Different sensors that extract RF power and convert it into a low-frequency signal for BIST purposes are available in the litterature [11][12] [13]. We have developed an envelope detector, with a very simple architecture, based on the following design constraints: (a) minimum silicon area overhead, (b) high input impedance in the frequency range of interest to avoid undesired loading of the CUC, (c) high dynamic range suitable for testing different on-chip CUCs, and (d) wide band of operation to monitor CUCs that work at different frequencies involved in the system.…”