Sensorless control of the high-speed switched reluctance generator of the micro power plant

Abstract

Introduction. In the distributed and autonomous generation systems using renewable energy sources, low-power generating units (not more than 100-200 kW) based on microturbines function. Microturbines operate most efficiently at high rotational speeds. In this regard, the generator running with a microturbine must also be a high-speed one. A generator is a switched reluctance electric machine (EM) that needs information on the rotor position. It is difficult to use a position sensor in such mechanisms at high speeds. This paper discusses the issues of sensorless control of a high-speed switched reluctance electric generator in conjunction with a steam microturbine.Materials and Methods. So, it is required to evaluate the proof-of-principle developed to control a high-speed switched reluctance EM. For this purpose, a mathematical model has been created including models of the investigated EM, an electric power converter, and a control system. For the EM under consideration, the active resistance is determined, as well as the dependence of the phase flux linkage on the current flowing through it and the position of the moving element. The method used involves probing the idle phase of an electric machine with short voltage pulses of equal duration, and measuring the current in this phase. If the voltage pulse length is much shorter than the phase time constant, then the current pulse amplitude is inversely proportional to the inductance. Thus, registering the maximum current pulse amplitude, it is possible to determine the rotor passage through an uncoordinated position for the probed phase. This information is used to form control actions by other phases. Moreover, the length of the test voltage pulses, required to obtain current pulses sufficient for measuring the value, is of significance versus the duration of the pulsing time. Hence, with an increase in the rotational speed, the number of test pulses is insufficient for measuring the position with the accuracy required for the control goals. This reduces drastically the precision of determining the rotor position; therefore, at high speeds, the application of this method is limited without further refinement of the rotor position. In this case, to increase the precision of measurements, it is necessary to evaluate the rate of current rise when applying the basic voltage pulse or the voltage pulse rate forming the phase current before switching to a single-pulse control mode. Research Results. Two conclusions important for correcting the estimation of the rotor position in a single-pulse operation mode of a reluctance EM are proved. The first conclusion is on the efficiency of the proposed technique of filtering phase current measurement data, the second one concerns the applicability of the identified information criteria. The analysis results of the processes in the switched reluctance EM using sensorless control that implements the described principles for determining the rotor position are presented.Discussion and Conclusions. To correct the estimation of the rotor position, the following information criteria can be used: the presence of a pause between the excitation pulse and the start of the generation process; the decrease in current by the time the generation begins. To refine the estimate, the following fact can be used: on the generation interval, the current curve knee corresponding to the maximum phase inductance is observed at the same rotor position.