1978
DOI: 10.1109/tns.1978.4329397
|View full text |Cite
|
Sign up to set email alerts
|

Semi-Autonomous Controller for Data Acquisition the Brilliant ADC

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
1
1
1
1

Citation Types

0
13
0

Year Published

1982
1982
1992
1992

Publication Types

Select...
8
2

Relationship

0
10

Authors

Journals

citations
Cited by 37 publications
(14 citation statements)
references
References 2 publications
0
13
0
Order By: Relevance
“…The signals from the wires in the SAM tracking system were discriminated using LeCroy Research Systems LD604 chips whose threshold was set to 0.5 mV. The time delays of these discriminated signals, corresponding to the drift times in the tracking tubes, were stored in SLAC TAC C C modules [2] and digitized using SLAC BADCs [3] . The signals from the wires in the shower counter were amplified by two-stage hybrid chips with a response of approximately 3 V output for 100 pC input.…”
Section: Detector Descriptionmentioning
confidence: 99%
“…The signals from the wires in the SAM tracking system were discriminated using LeCroy Research Systems LD604 chips whose threshold was set to 0.5 mV. The time delays of these discriminated signals, corresponding to the drift times in the tracking tubes, were stored in SLAC TAC C C modules [2] and digitized using SLAC BADCs [3] . The signals from the wires in the shower counter were amplified by two-stage hybrid chips with a response of approximately 3 V output for 100 pC input.…”
Section: Detector Descriptionmentioning
confidence: 99%
“…During the read out of a module, the analog output signals are sent to an "intelligent" digitizer (the BADC) [5]. F or each sample of the beam, 100 events are recorded at a rate of 20 Hz and the pulse heights for each strip are averaged.…”
Section: Beam Reconstructionmentioning
confidence: 99%
“…The signal on each readout strip is amplified and shaped at the detector to drive an output line. The analog signals are sampled at the peak by CAMAC-based sample-and~ hold modules (SHAMs [89]) and digitized by 12-bit ADCs in BADC (Brilliant ADC [90]) microprocessors which also perform pedestal subtraction, gain corrections, and threshold cuts determined from periodic calibration of the electronics by the injection of a varying charge at the amplifier. The memories of the BADCs are readout by CAMAC protocol by the host VAX computer.…”
Section: -Solid Pb Segmented Pbmentioning
confidence: 99%