Self Q-switching effect in a &lt;inline-formula&gt;&lt;math altimg="none" display="inline" overflow="scroll"&gt;&lt;mrow&gt;&lt;mi&gt;Nd&lt;/mi&gt;&lt;mo&gt;:&lt;/mo&gt;&lt;msub&gt;&lt;mi&gt;YVO&lt;/mi&gt;&lt;mn&gt;4&lt;/mn&gt;&lt;/msub&gt;&lt;mo&gt;∕&lt;/mo&gt;&lt;mi&gt;KTP&lt;/mi&gt;&lt;/mrow&gt;&lt;/math&gt;&lt;/inline-formula&gt; lasing unit

We report self-Q-switched operation of a Cr:LiCAF laser for the first time to our knowledge. Self-Q-switching (SQS) refers to the generation of a periodic train of Q-switched pulses from a laser cavity containing only the gain medium. Since SQS does not require any additional elements such as saturable absorbers or active modulators, it is far simpler and lower cost in comparison with other Q-switching methods. In the experiments, SQS operation was observed by using an x-shaped, astigmatically compensated laser cavity which contained only the Cr:LiCAF gain medium. A 140 mW, single-mode continuous wave (cw) diode at 660 nm was used as the pump source. In typical cw operation, the Cr:LiCAF laser produced output powers as high as 50 mW with about 50% slope efficiency. The laser had a diffraction-limited output and had a spectral width of about 0.5 nm near 795 nm. SQS operation could be initiated by fine tuning of the separation between the curved mirrors of the cavity and occurred at several discrete separations of the curved mirrors within the stability range of the resonator. Pulsed pumping of the pump diode, active cooling of the gain medium, and/or misalignment of the cavity end mirrors was not necessary to initiate SQS operation. In the SQS regime, the Cr:LiCAF laser produced about 5 μs wide pulses at repetition rates between 10 and 30 kHz. The corresponding pulse energies and peak powers were as high as 3.75 μJ and 590 mW, respectively. SQS operation was further accompanied with (i) a decrease in the output power to the 30-45 mW range, (ii) an increase of the spectral bandwidth up to 10 nm (full width at halfmaximum), and (iii) a switching of the laser output from pure TEM 00 to a structured beam containing higher-order spatial modes. We present detailed experimental data describing the temporal, spectral, and spatial characteristics of the SQS Cr:LiCAF laser, as well as the effect of curved mirror separation on SQS. The power-dependent repetition rate data were further analyzed to estimate the effective small-signal loss coefficient of the saturable absorber action.

show abstract

scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.

Contact Info

hi@scite.ai

10624 S. Eastern Ave., Ste. A-614

Henderson, NV 89052, USA

Blog Terms and Conditions API Terms Privacy Policy Contact Cookie Preferences Do Not Sell or Share My Personal Information

Made with 💙 for researchers

Part of the Research Solutions Family.

Self Q-switching effect in a <inline-formula><math altimg="none" display="inline" overflow="scroll"><mrow><mi>Nd</mi><mo>:</mo><msub><mi>YVO</mi><mn>4</mn></msub><mo>∕</mo><mi>KTP</mi></mrow></math></inline-formula> lasing unit

Cited by 4 publications

References 10 publications

Optical Channel Waveguides in $\hbox {KTiOPO}_{4}$ Crystal Produced by Proton Implantation

Optical Channel Waveguides in $\hbox {KTiOPO}_{4}$ Crystal Produced by Proton Implantation

Guided-wave phase-matched second-harmonic generation in KTiOPO 4 waveguide produced by swift heavy-ion irradiation

Self-Q-switched Cr:LiCAF laser

Contact Info

Product

Resources

About