Selection of the Parameters of 6- to 10-kV Cable Lines when Calculating and Simulating Transient Processes with Single-Phase Earth Faults

Shuin, V.A.; Shadrikova, T.Yu.; Deng, Yu

doi:10.3103/s1068371221120129

Cited by 2 publications

(1 citation statement)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Single phase grounding fault leads to the rise of non fault phase voltage. Long time operation with fault will damage the line insulation and develop into more serious phase to phase fault or even three-phase short circuit fault [2][3] . Therefore, for 10 kV distribution networks, this paper designs a reliable grounding fault location method based on traveling wave theory.…”

Section: Introductionmentioning

confidence: 99%

Method of grounding fault in 10-kV distribution network based on traveling wave theory

zhan,

Wei,

2023

Second International Conference on Energy, Power, and Electrical Technology (ICEPET 2023)

View full text Add to dashboard Cite

When there is a fault in a power line, due to the compensation effect of the arc suppression coil, it is difficult to obtain the fault signal and increase the difficulty of location. Therefore, based on traveling wave theory, this paper designs a reliable grounding fault location method suitable for 10 kV distribution networks. According to the fault information at the detection point, the traveling wave energy is calculated using wavelet energy spectrum to directly determine the fault section. If the energy of a certain two detection points is significantly higher than that of other measurement terminals, it is determined that the line between the two detection points is a faulty branch. For multiple ranging results, Grubbs test method is used to eliminate abnormal values and determine the fault location. The test results show that the accuracy of the ground fault location results obtained by this method is high and feasible.

show abstract

Section: Introductionmentioning

confidence: 99%