Selection of asphalt–concrete mixed compositions in cold recycling of road surfaces

Seliverstov, N. D.

doi:10.1134/s1995421216010184

Cited by 6 publications

(3 citation statements)

References 1 publication

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Definition of the parameters should be considered for optimal RAP (recycled asphalt pavement) and new hot, cold or warm asphalt mix composition and optimal pavement quality requirements [9].…”

Section: Fig 1 the Road Recycler Complex Systemmentioning

confidence: 99%

The Definition of the Parameters of Innovative Transport and Technological Equipment for the In-Road Pavement Recycling, Using the Method of The Analysis of Fourth Coordinate of The Process

et al. 2021

View full text Add to dashboard Cite

The features of the workflow of innovative transport and technological machines with non-waste technology, multi-purpose machines, recyclers and others similar are described in the article. The calculation methodology for determining the optimal parameters of machines and modes of operation, based on method of the analysis of fourth coordinate (duration) of the operating cycle, is presented. Dependences for determination of the power drive units of recycler are given. The procedure allows optimizing the parameters of the individual equipment units and of the entire recycler machine is described.

show abstract

Section: Fig 1 the Road Recycler Complex Systemmentioning

confidence: 99%

The Definition of the Parameters of Innovative Transport and Technological Equipment for the In-Road Pavement Recycling, Using the Method of The Analysis of Fourth Coordinate of The Process

et al. 2021

View full text Add to dashboard Cite

show abstract

“…Coarse-grained, fine-grained fillers and fine powder are selected in such a way that the curve of particle size distribution is located in the zone bounded by the limit curves, and is as smooth as possible. The grain composition of the mineral mixture is calculated depending on the number of selected raw mineral materials and their grain compositions [14][15][16][17].…”

Section: Introductionmentioning

confidence: 99%

The Relationship of the Asphalt Mixtures Composition and Physical Mechanical Characteristics of the Coating

Trautvain

Yakovlev

Grichanikov

et al. 2019

MSF

View full text Add to dashboard Cite

In the course of the work performance the following surveys were carried out: the analysis of the information assurance of the asphalt concrete mixtures production quality, the study of the relationship between the composition of asphalt concrete mixtures and the physical and mechanical characteristics of the coating. This paper presents the results of the analysis of the two types asphalt concrete mixtures qualitative composition and its effect on the physical, mechanical and technological characteristics of the coating. It is established that the deviation of asphalt concrete mixtures in composition from the required values leads to their under-compaction in the coating. It was also found that the increase in the number of inconsistencies in the composition of the asphalt concrete mixture leads to the increase in physical and mechanical characteristics that differ from the requirements of GOST 9128-2013 and GOST 31015-2002. The amount of bitumen on the asphalt concrete main characteristics, the data from the existing AP in the Belgorod Region were used as the information base in assessing the influence of granulometry of the asphalt concrete mineral part. Analysis of the particle size distribution was carried out using the laser analyzer for asphalt concrete AP 7 / 35B. The obtained data will be the basis for further study of the various parameters influence on the asphalt mixes properties, as well as improving the efficiency of the asphalt mix production control system.

show abstract

“…The preparation of a new mixture with the use of asphalt granulate provides for its fragmentation into smaller fractions, sieving into fractions and surface processing [6,9]. Calculating the cost of asphalt granulate crushing that goes to asphalt-concrete plant after milling is given in Table 2.…”

Section: Introductionmentioning

confidence: 99%

Calculation Peculiarities of Re-Processed Road Covering Unit Cost

Kyazymovna¹,

Dmitrievich²

2017

IJAS

View full text Add to dashboard Cite

Selection of asphalt–concrete mixed compositions in cold recycling of road surfaces

Cited by 6 publications

References 1 publication

The Definition of the Parameters of Innovative Transport and Technological Equipment for the In-Road Pavement Recycling, Using the Method of The Analysis of Fourth Coordinate of The Process

The Definition of the Parameters of Innovative Transport and Technological Equipment for the In-Road Pavement Recycling, Using the Method of The Analysis of Fourth Coordinate of The Process

The Relationship of the Asphalt Mixtures Composition and Physical Mechanical Characteristics of the Coating

Calculation Peculiarities of Re-Processed Road Covering Unit Cost

Contact Info

Product

Resources

About