Selection and Impact of an Aerofoil Leading Edge on Boundary Layer Transition

Abstract

The choice of leading-edge aspect ratio (AR) plays a crucial role when planning boundary layer wind tunnel tests on a flat plate. Poor selection of the leading-edge profile hampers effectiveness of the experiment and increases testing costs associated with interchanging of leading edges to attain accurate results. Thus, the appropriate selection of the leading edge is a very crucial part of the wind tunnel experiment process. It is argued that the curvature of the leading edge and thus the AR is of paramount importance to achieve accurate results from the wind tunnel testing. In this project, seven different elliptical leading edges were tested, and their performance was compared with an ideal leading edge with zero thickness. Experiments and computation have been done for leading edges ranging from AR6 to AR20. Results were evaluated for boundary layer transition onset location, and it was found that AR20 has the least influence on the flow structure when compared to the ideal leading edge. A study of the flow structure at the stagnation point indicates an increase in adverse pressure gradient with an increase in the AR but also shows a decrease in the size of the stagnation region. The presence of a higher AR leading edge reduces the turbulent spot production rate, which is one of the primary causes of boundary layer transition. This paper presents a correlation that enables aerodynamicists to quantify the impact of the leading-edge AR on transition. A typical case is also presented to compare the relative performance of a wedge and the higher AR leading edge, which provides a choice between an elliptical or a wedge-shaped leading edge.