Scaled Model Simulation and Experimental Verification of Submarine Flexible Pipeline Laying System

Abstract

In order to adapt to the complex and changeable marine environment such as wind, wave, and current, the physical simulation experiment is usually needed in the design of a deep-sea flexible pipeline-laying system. In reality, the flexible pipeline-laying system is very large, and the experimental cost is huge. Therefore, when analyzing this system, it is necessary to carry out scaled model experiments to verify the rationality of it. Taking the flexible pipeline-laying system working under four-level sea conditions as an example, this paper deduces the similarity criteria of the scaled model according to the similarity theory. According to the required experimental site, the sizes and materials of the model are selected, and then the physical quantities of the model and their similarity ratio corresponding to the prototype are determined. According to the physical quantities of the experimental model, the similarity of dynamic characteristics and structural strength between the model and the prototype are verified by Adams and ANSYS Workbench. The research shows that the scaled model and prototype based on similarity theory can meet the established similarity relationship, and the scaled model experiment is an effective way to verify the rationality of the design of a flexible pipeline-laying system.

Research on Contact Anchoring Theory and Contact Optimization of Underwater Pipeline Recovery Tools

“…One of the most popular means of shipping oil and gas by sea is through submarine pipelines, which have clear benefits in terms of reliability, economics, and efficiency [1]. The development of maintenance and operation technologies for underwater pipelines for the transfer of oil and gas has drawn interest from all around the world as maritime resources have grown [2].…”

Simulation study on mechanical wear of the diamond grain cutting pipeline steel

“…By now, Offshore Oil Engineering has completed more than 2200 km of subsea pipeline laying, and the maximum laying depth has reached 1542 m. Subsea pipelines are constantly exposed to high pressure and loads, which result in aging, corrosion, and even buckling, so cutting and replacement of damaged pipelines are required to avoid huge losses caused by oil and gas leakage. [1][2][3][4] The current subsea pipelines are mostly composite structures with X65 pipeline steel covered by different material layers, and the traditional cutting method cannot complete the cutting of the pipeline at once. To tackle the problems above, diamond bead wire cutting technology was introduced into subsea cutting operations.…”