Safety of Active Implantable Devices During MRI Examinations: A Finite Element Analysis of an Implantable Pump

Abstract

Abstract-The goal of this study was to propose a general numerical analysis methodology to evaluate the magnetic resonance imaging (MRI)-safety of active implants. Numerical models based on the finite element (FE) technique were used to estimate if the normal operation of an active device was altered during MRI imaging. An active implanted pump was chosen to illustrate the method. A set of controlled experiments were proposed and performed to validate the numerical model. The calculated induced voltages in the important electronic components of the device showed dependence with the MRI field strength. For the MRI radiofrequency fields, significant induced voltages of up to 20 V were calculated for a 0.3T field-strength MRI. For the 1.5 and 3.0T MRIs, the calculated voltages were insignificant. On the other hand, induced voltages up to 11 V were calculated in the critical electronic components for the 3.0T MRI due to the gradient fields. Values obtained in this work reflect to the worst case situation which is virtually impossible to achieve in normal scanning situations. Since the calculated voltages may be removed by appropriate protection circuits, no critical problems affecting the normal operation of the pump were identified. This study showed that the proposed methodology helps the identification of the possible incompatibilities between active implants and MR imaging, and can be used to aid the design of critical electronic systems to ensure MRI-safety.Index Terms-Biomedical equipment safety, finite element methods, magnetic resonance imaging.

In Vivo Study of Flow-Rate Accuracy of the MedStream Programmable Infusion System

“…The MedStream pump design was refined by finite element modeling to minimize interferences with MRI (26). The pump lacks magnetic rotors or rotating parts that are susceptible to MRI magnetic fields.…”

Programmable Infusion Pump and Catheter: Evaluation Using 3-Tesla Magnetic Resonance Imaging

“…The remaining drug volume within the reservoir is detected by a fill level sensor, which determines the volume of the reservoir chamber and converts the calculation to determine the remaining drug volume. Importantly, prior published work from our laboratory (10), has demonstrated the use of finite element modeling (ANSYS Emag 9, Canonsburg, PA, USA) to limit susceptibility of the pump electronics to induced voltages created by MRI‐related electro‐magnetic fields.…”

A Review of Numerical Simulation and Analytical Modeling for Medical Devices Safety in MRI

“…For the magneto-static problem, for the interaction of the field with complex geometries, the most used method is the FEM. For the gradient field for which the frequency is a few kHz, approximations can be made on the Maxwell equations and the most common method used is the FEM [7].…”