Runtime Extension of Low-Power Wireless Sensor Nodes Using Hybrid-Storage Units

Abstract

Abstract-The sensor nodes of wireless sensor networks remain inactive most of the time to achieve longer runtimes. Power is mainly provided by batteries, which are either primary or secondary. Because of its internal impedance, a significant voltage drop can appear across the battery terminals at the activation time of the node, thus preventing the extraction of all the energy from the battery. Additionally, internal losses can also be significant. Consequently, the runtime is reduced. The addition of a supercapacitor in parallel with the battery, thus forming a hybrid-storage device, has been proposed under pulsed loads to increase the power capabilities and reduce both the voltage drop and the internal losses at the battery. However, this strategy has not yet thoroughly been analyzed and tested in low-power wireless sensor nodes. This paper presents a comprehensive theoretical analysis that extends previous works found in the literature and provides design guidelines for choosing the appropriate supercapacitor. The analysis is supported by extensive experimental results. Two low-capacity (< 200 mAh) batteries were tested together with their hybrid-storage unit counterparts when using an electronic load as a pulsed current sink. The hybrid-storage units always achieved a higher runtime. One of the batteries was also tested using a sensor node. The runtime extension was 16% and 33% when connecting the hybrid-storage unit directly and through a dc-dc switching regulator to the sensor node, respectively. Index Terms-Autonomous sensor, battery impedance, hybrid storage, runtime extension, sensor node, wireless sensor networks (WSNs).

Design and Testing of a Kinetic Energy Harvester Embedded Into an Oceanic Drifter

“…From then, many conversion systems have been developed depending on the energy source; a summary is presented in [22]. On the other hand, the ESE can be a regular capacitor, a supercapacitor, a rechargeable battery, or even an hybrid system [23].…”

Hybrid Energy Storage System for Hybrid and Electric Vehicles: Review and a New Control Strategy

“…Till now, the most common battery-ultracapacitor hybrid topology is the passive hybrid, which has been studied by many researchers [22][23][24][25] and employed in commercial products [26][27][28]. In a passive topology, as shown in Figure 3, the batteries and ultracapacitors are connected in parallel with each other and the load.…”

“…Therefore, a dictionary for battery can be pre-calculated based on the history data using (24). These history data are the output signal of the battery, which is under desired working condition, for instance, proper temperature, low frequency output current etc.…”

Structure Design of Wireless Sensor Nodes with Energy and Cost Awareness for Multichannel Signal Measurement

“…This can be reached through different approaches, such as improving the performance of node power support unit [Penella and Gasulla 2010]. The power consumption of the radio chip is the largest among all components inside a sensor node [Estrin 2002].…”