RSM models approach for optimization of the mechanical properties of electroless Ni-B-nanodiamond coating: An experimental and molecular dynamic simulation study

Yazdani, Sepehr; Vitry, Véronique

doi:10.1016/j.surfcoat.2022.129133

Cited by 10 publications

(1 citation statement)

References 58 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…It has the advantages of good plating ability, being suitable for a variety of substrates, simple equipment, and controllable coating thickness [4][5][6]. Ni-P alloy and Ni-B alloy are two common chemical deposition alloys [7][8][9][10]. The process cost of electroless deposition of Ni-B alloy is high, the deposition rate is slow, and the corrosion resistance of the coating is poor, while the performance of electroless deposition of Ni-P alloy coating is also very excellent regardless of the low test cost and high efficiency [11][12][13][14][15].…”

Section: Introductionmentioning

confidence: 99%

Study on Adhesion Properties and Process Parameters of Electroless Deposited Ni-P Alloy for PEEK and Its Modified Materials

Gao

Yang

et al. 2023

Coatings

View full text Add to dashboard Cite

Polyetheretherketone (PEEK) and its fiber-reinforced materials are thermoplastic polymer materials with broad application prospects. Depositing Ni-P alloy on them can improve their poor conductivity and electromagnetic shielding performance, and further expand their application field. The application effect of the plated parts is significantly impacted by the bonding strength between PEEK and coating. The bonding strength between non-metallic substrate and coating is largely influenced by the surface characteristics of the substrate. Therefore, it is significant to study how the surface roughness of PEEK materials and the modified fibers in materials affect the adhesion of the coating. In this study, Ni-P alloy was electroless deposited on PEEK, 30% carbon-fiber-reinforced PEEK (CF30/PEEK), and 30% glass-fiber-reinforced PEEK (GF30/PEEK) with varying surface roughness. The influence of surface roughness and modified fibers on the coating adhesion was studied. Additionally, the effect of the concentrations of nickel sulfate, sodium hypophosphite, pH, and temperature on the deposition rate of the coating was investigated for the three materials. Based on the highest deposition rate, the process parameters were then optimized. The results demonstrated that as surface roughness increased, adhesion between substrate and coating first increased and then decreased. The surface roughness Ra of 0.4 μm produced the highest coating adhesion. Additionally, fiber-reinforced PEEK adhered to coatings more effectively than PEEK did. The mechanism of the difference in bonding strength between different PEEK-modified materials and coatings was revealed. The optimal process parameters were: nickel sulfate: 25 g/L, sodium hypophosphite: 30 g/L, pH: 5.0, and temperature: 70 °C.

show abstract