Rolled‐Up Whispering‐Gallery Mode Optical Microcavities

Wang, Yunqi; Yang, Shuo; Huang, Gaoshan; Xu, Borui; Mei, Yongfeng

doi:10.1002/9783527813933.ch12

Cited by 1 publication

(3 citation statements)

References 111 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

Section: Introductionmentioning

confidence: 99%

“…3D semiconductor nano-and micro structures based on the folding and rolling of strained heterostructures have been reviewed in the past [11,12,19,39] and some attention has been given to their use as WGM resonators-either in the III-V material system or in other materials [19,[40][41][42][43]. Nevertheless, these reviews focus on the physical properties of the WGM resonators and their possible use as devices [40,42,43]. One aspect that is little discussed but offers a great potential for physics study and device tailoring is the strain-induced change of the optical properties of the emitters integrated into the initial heterostructure due to the roll-up process.…”

Section: Introductionmentioning

confidence: 99%

“…After this brief overview (for more details, the reader can be refereed to [40][41][42][43] as reviews), we like to point out that the fundamental problems like field leakage and low quality factors of the tube WGM resonators have to be addressed, e.g. by improving quality factors by coating [72].…”

Section: Introductionmentioning

confidence: 99%

See 2 more Smart Citations

Review: using rolled-up tubes for strain-tuning the optical properties of quantum emitters

Gomes

Gomes²,

Silva

et al. 2023

Nanotechnology

View full text Add to dashboard Cite

Rolled-up tubes based on released III-V heterostructures have been extensively studied and established as optical resonators in the last two decades. In this review, we discuss how light emitters (quantum wells and quantum dots) are influenced by the inherently asymmetric strain state of these tubes. Therefore, we briefly review whispering gallery mode resonators built from rolled-up III-V heterostructures. The curvature and its influence over the diameter of the rolled-up micro- and nanotubes are discussed, with emphasis on the different possible strain states that can be produced. Experimental techniques that access structural parameters are essential to obtain a complete and correct image of the strain state for the emitters inside the tube wall. In order to unambiguously extract such strain state, we discuss X-ray diffraction results in these systems, providing a much clearer scenario compared to a sole tube diameter analysis, which provides only a first indication of the lattice relaxation in a given tube. Further, the influence of the overall strain lattice state on the band structure is examined via numerical calculations. Finally, experimental results for the wavelength shift of emissions due to the tube strain state are presented and compared with theoretical calculations available in literature, showing that the possibility to use rolled-up tubes to permanently strain engineer the optical properties of build-in quantum emitters is a consistent method to induce the appearance of electronic states unachievable by direct growth methods.

show abstract