Role of steady state fluorocarbon films in the etching of silicon dioxide using CHF3 in an inductively coupled plasma reactor

Abstract

It has been found that in the etching of SiO2 using CHF3 in an inductively coupled plasma reactor of the planarized coil design, a thin steady state fluorocarbon film can play an important role in determining the rate of etching. This etching is encountered as the amount of bias power used in the SiO2 etching process is increased, and a transition from fluorocarbon film growth on the SiO2 to an oxide etching rate which is consistent with reactive sputtering theory is made. The observed presence of an intermediate region where etching occurs, although a steady state fluorocarbon film suppresses the etch rate from that expected for a reactive sputtering process, has been referred to as the fluorocarbon suppression regime. This work demonstrates the role of the steady state fluorocarbon film present on silicon dioxide during etching within the fluorocarbon suppression regime. X-ray photoelectron spectroscopy studies of the surfaces of partially etched SiO2 have shown a thinning of this film with increasing rf bias power, as well as a decrease in the fluorine content of the surface film as a function of increasing rf bias power. We have found that slight variations in the film thickness, on the order of 1 nm, can result in large variations, approximately 400 nm/min, in the silicon dioxide etch rate. The presence of the film within the suppression regime appears to be due to the overwhelming polymerization ability of high density plasmas, coupled with the inability of the oxide to react sufficiently with the total fluorocarbon particle flux in order to completely remove this film. For this reason these types of reactors exhibit a regime where oxide etching occurs in the presence of a surface film. The film appears to be directly responsible for the observed suppression of the oxide etch rate from that expected for a reactive sputtering process by dissipating the bombarding ion energy, and thereby suppressing the energy flux arriving at the oxide surface.

Atomic Layer Etching at the Tipping Point: An Overview

“…fairly rapid etching for one material and slow etching or deposition for another material. [20][21][22][23][24][25][26] However, the thicknesses of these steady-state surface layers can be of the order of several nm. During the time needed for these to form, significant material loss can take place.…”

Simulation of Si and SiO2etching in CF4+ H2plasma

“…The thickness of the fluorocarbon layer on SiO 2 is much smaller than on Si for comparable discharge conditions [4,5]. During Si etching in CF 4 + H 2 plasma the adsorption of CF 2 radicals on the Si surface is enhanced by ion bombardment, i. e. the sticking coefficient of CF 2 radicals on the Si surface is increased in the presence of ion bombardment [6].…”

TiO2 membrane high-contrast grating reflectors for vertical-cavity light-emitters in the visible wavelength regime

“…4(a)]. A higher ICP power on the other hand reduced the sidewall passivation at the bottom of the TiO 2 layer, resulting in an undercut profile 26 [see Fig. 4(b)].…”