Robust PID control of a buck-boost DC-AC converter

Cáceres, Ramón; Rojas, Rubén; Camacho, Oscar

doi:10.1109/intlec.2000.884248

Cited by 31 publications

(21 citation statements)

References 4 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…A doub control method [5][6][7][8] for the three-phase ied. The mode eq 2 S on t obtained, in which internal resistance have been neglected: rent will be flow through the 2 D ; otherwise the current will be flow through the 2 S .…”

Section: He Threementioning

confidence: 99%

See 1 more Smart Citation

The Research of Three-phase Boost/Buck-boost DC-AC Inverter

Li¹,

Yan²,

Gao³

et al. 2013

EPE

View full text Add to dashboard Cite

This paper presents a new inverter based on three-phase Boost/Buck-boost single-stage inverter. The basic configuration of the new topology and their fundamental principle are firstly introduced, the method of design double-loop controller and sliding mode controller are clarified, analyzed and compared in the following. Finally the validity and feasibility of the new topology are tested by simulation. The results indicate that regulation of the voltage transfer ratio and output frequency can be realized optionally by the new converter, furthermore the harmonic distortion of waveform is low. So the inherent drawback of low voltage transfer ratio of traditional converter is effectively settled. This study may provide inspiration for further engineering application.

show abstract

Section: He Threementioning

confidence: 99%

“…Concerning the output voltage loop which is introduced in Figure 6, is now defined by equation (5) equation (7). The design of the control structure for the output voltage is based on the same philosophy as the current loop.…”

Section: He Threementioning

confidence: 99%

The Research of Three-phase Boost/Buck-boost DC-AC Inverter

Li¹,

Yan²,

Gao³

et al. 2013

EPE

View full text Add to dashboard Cite

show abstract

“…Optimum ITAE is used as a deciding factor in design and tuning of controllers by many researchers, mainly Caceres et al [31] and Shrivastava [32]. Note that lower ITAE value implies better performance of the system.…”

Section: The Integrated Time-weighted Absolute Error (Itae) Criterionmentioning

confidence: 99%

Tuning fractional order proportional integral controllers for fractional order systems

Luo

Wang

Chen

2009

2009 Chinese Control and Decision Conference

View full text Add to dashboard Cite

“…To achieve these, the Proportional Integral (PI) controller is usually used [10]. However, when the system using PI controller under the case of a variable load rather than the nominal ones, cannot obtain fast and stable output voltage response.…”

Section: Introductionmentioning

confidence: 99%