Robust Adaptive MPPT Control of Wind Turbine Based on Prescribed Performance

Ran, Qilin; Jin, Fangjun

doi:10.1109/icpeca53709.2022.9719157

Cited by 1 publication

(2 citation statements)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In [31], a robust adaptive controller, which estimates parametric uncertainties of WT is proposed for improved robustness and MPPT efficiency. However, structural load migation is not considered in [27]- [31]. This objective is addressed in the proposed control scheme.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Adaptive Robust Observer-Based Control for Structural Load Mitigation and Speed Regulation in Commercial Wind Turbines

Kipchirchir,

Hung Do,

Njiri

et al. 2024

IEEE Access

View full text Add to dashboard Cite

As the size of wind turbines (WTs) increases, an additional increase in the structural load on the WT components is to be expected. This will have an impact on operational safety in terms of damage and service life. Spatial and temporal fluctuations in wind speed are responsible for the fatigue load during power generation. To minimize the effects of varying stresses, advanced control systems that incorporate appropriate models of the disturbances are proposed. These controllers are usually developed based on reduced-order models of nonlinear WTs so that they can minimize uncertainties such as modeling errors. Although robust controllers are able to deal with uncertainties, they are still only developed for design situations. Therefore, their performance can deteriorate significantly under very uncertain operating conditions. Adaptive controllers, on the other hand, are designed to consider multiple operating points in the design. However, most of these methods do not consider the optimization of different objectives in the design for structural load reduction or speed control of WTs. In this paper, a novel adaptive robust observerbased control strategy for structural load reduction and rotor speed regulation of commercial WTs operating at higher wind speed is proposed. To achieve this, a robust disturbance accommodating controller (RDAC) is combined with an adaptive pitch controller (aIPC). This adapts to changing operating points. The proposed control method is tested on a 1.5 MW reference WT (RWT) developed by the National Renewable Energy Laboratory (NREL). The simulation results show that, compared with the state of the art presented on a gain-scheduled proportional integral (GSPI) and RDAC controllers, the proposed control method reduces the structural load on the rotor blades by 10.7 % and 9.2 %, respectively, and on the tower by 36.2 % and 8.4 %, respectively. It therefore makes a key contribution to mitigating the structural dynamic loads on the WT by reducing the load on several WT components. This is achieved without any significant impact on the rotor speed and power control or the generated power under changing operating conditions.INDEX TERMS disturbance accommodating control, load mitigation, robust control, wind turbine.

show abstract

Section: Introductionmentioning

confidence: 99%

“…Improved performance compared with nonlinear PI (N-PI) and feedback linearized control schemes is reported. In [31], a robust adaptive controller, which estimates parametric uncertainties of WT is proposed for improved robustness and MPPT efficiency. However, structural load migation is not considered in [27]- [31].…”

Section: Introductionmentioning

confidence: 99%