rFRET: A comprehensive, Matlab‐based program for analyzing intensity‐based ratiometric microscopic FRET experiments

Abstract

Fluorescence or F€ orster resonance energy transfer (FRET) remains one of the most widely used methods for assessing protein clustering and conformation. Although it is a method with solid physical foundations, many applications of FRET fall short of providing quantitative results due to inappropriate calibration and controls. This shortcoming is especially valid for microscopy where currently available tools have limited or no capability at all to display parameter distributions or to perform gating. Since users of multiparameter flow cytometry usually apply these tools, the absence of these features in applications developed for microscopic FRET analysis is a significant limitation. Therefore, we developed a graphical user interface-controlled Matlab application for the evaluation of ratiometric, intensity-based microscopic FRET measurements. The program can calculate all the necessary overspill and spectroscopic correction factors and the FRET efficiency and it displays the results on histograms and dot plots. Gating on plots and mask images can be used to limit the calculation to certain parts of the image. It is an important feature of the program that the calculated parameters can be determined by regression methods, maximum likelihood estimation (MLE) and from summed intensities in addition to pixel-by-pixel evaluation. The confidence interval of calculated parameters can be estimated using parameter simulations if the approximate average number of detected photons is known. The program is not only user-friendly, but it provides rich output, it gives the user freedom to choose from different calculation modes and it gives insight into the reliability and distribution of the calculated parameters. V C 2016 International Society for Advancement of Cytometry

Linked colour imaging benefits the endoscopic diagnosis of distal gastric diseases

“…Typical endoscopic images for the lesions were analysed using MatLab software (USA), and the pixel brightness of the red, green and blue (RGB) colours for the targeted areas was calculated 7, 24 . The distance to the mucosa was estimated using the top (approximately 2 mm) of a transparent cap (DH-11GZ, FUJIFILM Co., Tokyo, Japan) for comparison when taking images.…”

Minimum degree of overlap between IL‐9R and IL‐2R on human T lymphoma cells: A quantitative CLSM and FRET analysis

“…Fluorescence intensity of a donor-acceptor doublelabeled sample recorded in three different fluorescence channels was analyzed by the rFRET program written in Matlab (Mathworks, Natick, MA) using DipImage functions (Delft University of Technology, Delft, The Netherlands) (23). Briefly, since membrane proteins were labeled, manuallyseeded watershed transformation was used to segment the image and to create the "mask image."…”

“…Briefly, since membrane proteins were labeled, manuallyseeded watershed transformation was used to segment the image and to create the "mask image." Finally, the FRET efficiency was calculated using maximum likelihood estimation after performing watershed segmentation on the donor-acceptor double-labeled sample (23,30). Finally, the FRET efficiency was calculated using maximum likelihood estimation after performing watershed segmentation on the donor-acceptor double-labeled sample (23,30).…”

“…While the Pearson correlation coefficient (C) is a good measure of correlation/anti-correlation between the two distributions, the area-or intensity-based measures of co-occurrence (the latter one is known as the Manders colocalization coefficient) give information about the fraction of overlap as well (20). Molecular scale interactions of the receptor chains were studied by confocal microscopic FRET experiments on a cell-by-cell basis, using a ratiometric, intensity-based FRET (rFRET) method (23). Molecular scale interactions of the receptor chains were studied by confocal microscopic FRET experiments on a cell-by-cell basis, using a ratiometric, intensity-based FRET (rFRET) method (23).…”

Detection of protein interactions by Subcellular Localization Assay

“…In the next step, Rolling Circle Amplification (RCA) will generate a single-stranded DNA product which is connected to one of the proximity probes and it contains several concatenated copies of the connector oligonucleotides. Nevertheless, for the quantitative measurements in the range of 2-10 nm, F€ orster resonance energy transfer (FRET) should be considered as a more reliable tool (9)(10)(11)(12)(13) and at the same time, the saturation features of PLA should be taken into account (14). Interpretation of the results of PLA are based on the assumption that a PLA signal is detectable if the proximity probes are located at a distance of tens of nanometers (7,8).…”