Review article: Atmospheric Pressure, Water with Air, Porosity and Strength of Concrete (In memory of Professor László A Gömze)

Abstract

The review shows that the gas content in tablets and solutions of medicines can significantly change their physical and chemical properties, qualitative and quantitative characteristics of the mechanism of action of medicines when applied topically, and even allows you to turn “old” and known medicines into “new” medicines with completely new and previously unknown mechanisms of action. Therefore, artificial changes in the gas content in solid and liquid dosage forms were recommended as an original method of developing new drugs. It has been shown that this method is particularly promising for the development of new antiseptic, cosmetic and hygiene products. The fact is that the additional forced introduction of gas into a liquid or into solid through excessive pressure increases their volume, reduces their specific gravity and strength. Moreover, it allows you to “blow up” them by cold boiling. Conversely, the removal of gas from them due to vacuum reduces the volume, increases the specific gravity and strength. By analogy with the change in the physical and chemical properties of liquid and solid medicines, achieved by removing gases from them, it is proposed to reduce the porosity and volume of concrete and increase its specific weight and strength by degassing the water used for wetting cement in the concrete manufacturing process. Due to the fact that under normal conditions, the gas content in the water used for the manufacture of concrete directly depends on the atmospheric pressure, it is concluded that the production of concrete at different atmospheric pressure changes its quality. In particular, low atmospheric pressure can reduce the porosity and volume of concrete, as well as increase the specific gravity and strength of concrete. On the other hand, high air and/or gas pressure can increase the porosity and volume of concrete and reduce the concrete’s specific gravity and strength. Therefore, the amount of atmospheric pressure and/or air and/or gas pressure on concrete during its production should be included in the list of controlled indicators of concrete manufacturing technology.