RETRACTED: Fe–Cr–Ni–Zr alloys with bi-modal grain size distribution: Synthesis, mechanical properties and oxidation resistance

Mahesh, B.V.; Raman, R.K. Singh; Scattergood, R.O.; Koch, Carl C.

doi:10.1016/j.msea.2013.02.049

Cited by 6 publications

(1 citation statement)

References 56 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The presence of pores and crystal defects in NS1A matrix and its high hardness could be the reason for the low strength and strain [47]. Mahesh et al [48] reported that nanocrystalline Fe-Cr powder exhibited a difficult plastic deformation due to its high hardness. However, the combination of nano-and microstructure in BM1A resulted into a high shear stress and shear strain (420.28±35…”

Section: Accepted Manuscriptmentioning

confidence: 99%

Design and characterization of nano and bimodal structured biodegradable Fe-Mn-Ag alloy with accelerated corrosion rate

Bagha

Khakbiz

Sheibani

et al. 2018

Journal of Alloys and Compounds

View full text Add to dashboard Cite

Researchers in biodegradable metals have been putting efforts to accelerate the corrosion of ironbased biodegradable metals. These include by alloying iron with manganese and noble elements such as silver, but further increase to the corrosion rate is still needed. In this study, a set of bimodal nano/microstructured Fe-30Mn-1Ag alloys was prepared through mechanical alloying and spark plasma sintering. The alloys were characterized and tested for their corrosion behavior in Hanks' solution at 37 o C and for their mechanical properties. The bimodal-structured alloy possessed a mixture of austenitic (γ-FeMn) and ferritic (α-Fe) phases, while the nano-and macro-structured ones were essentially composed of γ-FeMn and α-Fe phases, respectively. Addition of 1-3 wt.% of silver into the nanostructured alloy increased its corrosion rate from 0.24 mm/year to 0.33 and 0.58 mm/year for Fe-30Mn-1Ag and Fe-30Mn-3Ag, respectively. Whilst, the bimodal Fe-30Mn-1Ag alloy corroded at a higher rate of 0.88 mm/year. This alloy also possessed an interesting combination of high and low micro-hardness phases that contributed to high shear strength of 417 MPa and shear strain of 0.66. Detailed discussion on the relationship of microstructure with corrosion behavior and mechanical properties is presented in this manuscript.

show abstract

Section: Accepted Manuscriptmentioning

confidence: 99%