RETRACTED: Design and implementation of novel soft switching method based DC-DC converter with non-isolated coupled inductor in solar system using FPGA

Umadevi, K.; Nagarajan, C.

doi:10.1016/j.micpro.2019.102952

Cited by 12 publications

(4 citation statements)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Parameters of the Soft Switched Converter with Coupled Inductor values are designed [22] as shown in Table 2. The mechanism of PSO-DFFP is inspired by the complex social behavior shown in Fig.…”

Section: Design Of Pso-dffp Controllermentioning

confidence: 99%

“…This formulation directly and directly controls the aggregate demand of AC clusters in decentralized houses and decentralized and centralized Model Predictive Control (MPC) strategies for solar power balance fluctuations. Dynamic power flow management system for photovoltaic (PV) systems Dual input/output DC-DC converter using a single inductor-based single stage to supply a standalone DC load, backed up by a secondary battery [19][20][21][22][23][24][25][26][27][28][29][30].…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Performance Analysis of PSO DFFP Based DC-DC Converter with Non Isolated CI using PV Panel

Nagarajan

Umadevi²,

Saravanan³

et al. 2022

IJRCS

View full text Add to dashboard Cite

This article presents the modeling and development of a DC-DC converter with Partial Swarm Optimization with Distinctive Feed Forward Propagation (PSO-DFFP) controller for hybrid power systems, including photovoltaic panels. The transient and dynamic analysis of the proposed controller has been presented. The PSO-DFFP controller has been designed to improve the operating efficiency and reduces the input converter current ripple. The ANFIS and PSO DFFP controllers are developed, and the performance of the system is compared. The proposed system reduces the switching losses and voltage drops in switching modes. The proposed system is demonstrated and developed with a 200W, 100kHz model. From the experimental results, it can be exposed that the proposed system is acceptable for PV applications.

show abstract

Section: Design Of Pso-dffp Controllermentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Performance Analysis of PSO DFFP Based DC-DC Converter with Non Isolated CI using PV Panel

Nagarajan

Umadevi²,

Saravanan³

et al. 2022

IJRCS

View full text Add to dashboard Cite

show abstract

“…Prasad et al (2016) has been developed the DPFM system for solar systems was presented. The transient and dynamic invigoration of the converter was not analyzed (Nagarajan and Madheswaran, 2012;Nagarajan and Mathiyalagan, 2012;Nagarajan et al, 2013;Umadevi and Nagarajan, 2020;Lakshmi and Nagarajan, 2021;Nagarajan et al, 2021Nagarajan et al, , 2022. Nagarajan et al (2022) have developed the hybrid intelligent controller using RPF technique was presented.…”

Section: Introductionmentioning

confidence: 99%

Performance investigation of ANFIS and PSO DFFP based boost converter with NICI using solar panel

Nagarajan¹,

Umadevi²,

Saravanan³

et al. 2022

Int. J. Eng. Sci. Tech

View full text Add to dashboard Cite

The modeling and development of the boost DC to DC converter with Partial Swarm Optimization with Distinctive Feed Forward Propagation (PSO-DFFP) controller for hybrid power systems including solar panels. The static and dynamic investigation of the developed PSO DEEP controller is presented. The PSO-DFFP controller has been designed to improve the operating efficiency and reduces the input converter current ripple. The PSO DFFP controller is developed and performance is compared with ANFIS and FLC. The developed system reduces the switching losses and voltage drops in switching modes. The designed system is demonstrated and developed with 200W, 100kHz model. The investigation results is exposed that the developed PSO DEEP system is an acceptable for SOLAR applications.

show abstract

“…Studies using the estimated values obtained as a result of ANFIS training can give better results than traditional methods [20]. Estimated power values and control signals needed by simple structured power electronics circuits such as direct current to direct current (DC-DC) converters [21] can be produced. While voltage source converters (VSC) can be recommended for irregular operating conditions [22], power modules fed by PV panels and capable of producing AC directly can be driven by ANFIS [23].…”

Section: Introductionmentioning

confidence: 99%

ANFIS Based Real-Time Power Reference Generator for PV Applications

Gökkuş

2022

ECJSE

View full text Add to dashboard Cite

In this study, a real-time power estimation of a 250Wp solar panel is performed by using a commercial product SIS01-TC-T PV reference module and STM development board. Power estimation was carried out with Adaptive Neuro-Fuzzy Inference System (ANFIS). During the training process, the actual values of the Photo Voltaic (PV) panel with a 250Wp power were used. ANFIS training was accomplished with the hybrid learning algorithm. The power estimation process can be used as a reference power for various applications. The estimated power value can be used in real-time power monitoring for remote monitoring systems or optimum angle control applications for solar tracking mechanisms. It can also be used as a reference value for hybrid Maximum Power Point Tracking (MPPT) control applications or Proportional, Integral, and Derivative (PID) control. In addition, with this reference power value, the Pulse Width Modulation (PWM) signal required by various power electronics stages can be generated.

show abstract

RETRACTED: Design and implementation of novel soft switching method based DC-DC converter with non-isolated coupled inductor in solar system using FPGA

Cited by 12 publications

References 15 publications

Performance Analysis of PSO DFFP Based DC-DC Converter with Non Isolated CI using PV Panel

Performance Analysis of PSO DFFP Based DC-DC Converter with Non Isolated CI using PV Panel

Performance investigation of ANFIS and PSO DFFP based boost converter with NICI using solar panel

ANFIS Based Real-Time Power Reference Generator for PV Applications

Contact Info

Product

Resources

About