Response Surface Methodology for Optimization of Rotating Biological Contactor Combined with External Membrane Filtration for Wastewater Treatment

Abstract

A large amount of wastewater is directly discharged into water bodies without treatment, causing surface water contamination. A rotating biological contactor (RBC) is an attached biological wastewater treatment process that offers a low energy footprint. However, its unstable removal efficiency makes it less popular. This study optimized operating parameters in RBC combined with external membrane filtration (RBC-ME), in which the latter acted as a post-treatment step to stabilize the biological performance. Response surface methodology (RSM) was employed to optimize the biological and filtration performance by exploiting three parameters, namely disk rotation, hydraulic retention time (HRT), and sludge retention time (SRT). Results show that the RBC-ME exhibited superior biological treatment capacity and higher effluent quality compared to stand-alone RBC. It attained 87.9 ± 3.2% of chemical oxygen demand, 45.2 ± 0.7% total nitrogen, 97.9 ± 0.1% turbidity, and 98.9 ± 1.1% ammonia removals. The RSM showed a good agreement between the model and the experimental data. The maximum permeability of 144.6 L/m2 h bar could be achieved under the optimum parameters of 36.1 rpm disk rotation, 18 h HRT, and 14.9 d SRT. This work demonstrated the effective use of statistical modeling to enhance RBC-ME system performance to obtain a sustainable and energy-efficient condition.

Response Surface Methodology and Artificial Neural Network Modelling of Membrane Rotating Biological Contactors for Wastewater Treatment

“…The synthetic wastewater was prepared by blending refined food leftovers (1 g/L) as suggested in previous work [ 39 ]. After mixing food leftovers with water, the mixture was left for 2 h to settle the suspended particles.…”

Confounding Effect of Wetting, Compaction, and Fouling in an Ultra-Low-Pressure Membrane Filtration: A Review

“…On a household scale, a compact membrane system can easily be cleaned by mechanical hand-shaking [ 68 , 73 ] or rinsed with a detergent solution ( accessed on 19 April 2022). Like a rotary system that allows module rotation [ 74 ], innovative module systems are also practical in small-scale ULPM systems to allow a certain degree of membrane cleaning. Overall, the concept of a membrane system without cleaning can still be revisited to enhance the system throughput but without ignoring the niche of robust systems, which can operate without electricity but still be adaptive to available resources to enhance the system throughput.…”

Nanofiltration PVP Membrane with Gradient Cross-Linking for Efficient Polycyclic Aromatic Hydrocarbons Removal

“…Polysulfone is one of the most prevalent polymers for membrane casting due to its outstanding mechanical, high thermal, and excellent chemical stability with relatively low cost and suitable flux. − It is hydrophobic, but hydrophilicity can be enhanced by adding inorganic filler into a membrane with a wide aperture adjustment range. , Poly­(vinylpyrrolidone) (PVP) is a nonconducting, biocompatible, and nontoxic polymer with an excellent performing agent and is known as one of the most used membrane additives. − It is soluble in polar solvents with good adhesion and applied as a morphology controller. ,, It also enhanced the viscosity of the casting solution and leached out into the water during membrane synthesis . Due to being hydrophilic, it enhances the antifouling properties of polymer membranes. , Due to its good performance, epichlorohydrin (ECH) is a cationic water-soluble additive that provides permanent wet strength in alkaline conditions.…”