Residual Stress, Nanohardness, and Microstructure Changes in Whirlwind Milling of GCr15 Steel

Experimental and numerical analyses of residual stress redistributions in large steel dies: Influence of tempering cycles and rough milling

“…The residual stress distribution after milling operations was measured in several research works. Guo et al [10] analyzed the residual stresses induced by the whirlwind milling of AISI 52100 Steel. The results showed that high compressive residual stresses were produced in steel specimens.…”

Investigation on the effect of cutting fluid pressure on surface quality measurement in high speed thread milling of brass alloy (C3600) and aluminium alloy (5083)

“…External thread milling and whirlwind operations involve complicated machining approaches due to their elaborate tool geometry, effects of this tridimensional tool trajectory have not yet been fully understood [23][24][25]. Different aspects of thread milling such as cutting force, cutting parameters, various cutting lubrications, cutting tool angle, wear and interference have been discussed by researchers using mathematical and numerical models [26][27][28].…”