Relationships Among Particle Number, Surface Area, and Respirable Mass Concentrations in Automotive Engine Manufacturing

Abstract

This study investigated the relationships between particle number, surface area, and respirable mass concentration measured simultaneously in a foundry and an automotive engine machining and assembly center. Aerosol concentrations were measured throughout each plant with a condensation particle counter for number concentration, a diffusion charger for active surface area concentration, and an optical particle counter for respirable mass concentration. At selected locations, particle size distributions were characterized with the optical particle counter and an electrical low pressure impactor. Statistical analyses showed that active surface area concentration was correlated with ultrafine particle number concentration and weakly correlated with respirable mass concentration. Correlation between number and active surface area concentration was stronger during winter (R2 = 0.6 for both plants) than in the summer (R2 = 0.38 and 0.36 for the foundry and engine plant respectively). The stronger correlation in winter was attributed to use of direct-fire gas fired heaters that produced substantial numbers of ultrafine particles with a modal diameter between 0.007 and 0.023 mu m. These correlations support findings obtained through theoretical analysis. Such analysis predicts that active surface area increasingly underestimates geometric surface area with increasing particle size, particularly for particles larger than 100 nm. Thus, a stronger correlation between particle number concentration and active surface area concentration is expected in the presence of high concentrations of ultrafine particles. In general, active surface area concentration may be a concentration metric that is distinct from particle number concentration and respirable mass concentration. For future health effects or toxicological studies involving nano-materials or ultrafine aerosols, this finding needs to be considered, as exposure metrics may influence data interpretation.

Occupational exposure to fungi and particles in animal feed industry

“…The use of these two metrics simultaneously in occupational exposure assessments has only been done recently and in a small number of studies [35] but it seems of extreme importance because it gives more complete and accurate data to perform risk assessment [36].…”

On the friction coefficient of straight-chain aggregates

“…Ref. [17]). It is more convenient to eliminate the proportionality constant by considering the drag force f k relative to the total drag on k isolated monomers f 1 ,…”

Determining Nanoparticle Inhalation Exposure in the Prosthetics Laboratory at Walter Reed National Military Medical Center

“…The OPC data should be used to determine which portion of the CPC data is below the limit of the OPC (43). Heitbrink et al proposed a method to make that determination (19). Utilizing the fact that the detectable sizes for the two meters overlap, the size channels of the OPC that are below the 1000nm upper detection limit of the CPC are subtracted from the OPC's count.…”

“…The number 3 is the OPC channel for which the upper limit is 1000nm for the meter used by Heitbrink et al (19). As the lowest limit from the OPC's first channel is 300nm and the upper limit of the third channel is 1000nm, Nufp is solely the 20nm to 200nm particle count range (19; 55).…”

“…The diameter of the channel was obtained from OPC specifications. This method completed the fraction obtained from the count-difference method (19). The geometric mean was used because of decrease sensitivity to outliers.…”