Relation between Faradic Yields, Hydrogen Evolution and Pulsed Currents: Morphological and Fe Content Control in Zn and ZnFe Coatings

Abstract

Long-term protection of metallic parts from atmospheric exposure is an important challenge and one of the most frequent way to ensure their corrosion resistance is the application of sacrificial zinc alloys coatings [1]. Among the various zinc electroplating baths, the alkaline zincate solutions has gained a wide range of applications thanks to its simple bath composition, good dispersion and efficient coverage ability. Nevertheless, its efficiency is very low in absence of additives, which affects the performances of the coatings by modifying the crystal growth and therefore the structural and mechanical properties. This is a result from the competition between dihydrogen production and the reduction of the metallic species present in the bath.The present study deals with the optimization of ZnFe sacrificial coating on steel and aluminum substrate in the frame of the ATLAS project -Alternative TechnoLogies for improved Anticorrosion Solutions- managed by the IRT M2P. After the analysis of the electrochemical behavior of the ZnFe electrolyte patented by the Coventya company and the UTINAM institute, pulsed currents will be implemented to extend the versatility of the coatings. Indeed, pulsed currents are known to act on various parameters such as improving the faradic yield or modifying morphologies and structures [2].The determination of a first panel of pulsed sequences (average current densities, cathodic peak current, cathodic pulse time and off-time) have been based on transient curves analysis from a zincate bath. Three sequences have been selected as they resulted in very different patterns in terms of electrochemical behavior and coatings characteristics. These sequences have been replicated and compared to DC current in several electrolytes, from the zincate bath to the commercial formula. For each set of parameters, the faradic yield has been measured and compared to the hydrogen generated during the electrolysis distributed between the absorbed one (measured by hot extraction) and the dihydrogen released into the reactor atmosphere (measured by mass spectrometry with a dedicated set- up). It is interesting to note that the obtained values strongly depend on pulsed sequences as well as electrolytes composition. Coatings were systematically produced and characterized. Morphology was observed using SEM and microstructure determined from XRD diffractograms: preferential orientation and crystal lattice and crystalline phases. The latest has required a specific methodological development.Finally, the identification of nucleation parameters by model simulation has been undertaken to describe the mechanisms involved in the first steps of zinc electrodeposition [3].[1] B. Chatterjee, « Electrodeposition of Zinc Alloys », p. 31.[2] X. Zhang, K. Tsay, J. Fahlman, and W. Qu, « Journal of Energy Storage, 26 p. 100966 (2019)[3] A. Milche, Electrochimica Acta, 48 p.2903-2913 (2003)