Reduced Overhead Routing in Short-Range Low-Power and Lossy Wireless Networks

Abstract

In this paper we present enhanced routing protocol for low-lower and lossy networks (ERPL), a reduced overhead routing protocol for short-range low-power and lossy wireless networks, based on RPL. ERPL enhances peer-to-peer (P2P) route construction and data packet forwarding in RPL’s storing and non-storing modes of operation (MoPs). In order to minimize source routing overhead, it encodes routing paths in Bloom Filters (BF). The salient features of ERPL include the following: (i) optimized P2P routing and data forwarding; (ii) no additional control messages; and (iii) minimized source routing overhead. We extensively evaluated ERPL against RPL using emulation, simulation, and physical test-bed based experiments. Our results demonstrate that ERPL outperforms standard RPL in P2P communication and its optimized P2P route construction and data forwarding algorithms also positively impact the protocol’s performance in multi-point to point (MP2P) and point to multi-point (P2MP) communications. Our results demonstrate that the BF-based approach towards compressed source routing information is feasible for the kinds of networks considered in this paper. The BF-based approach results in 65% lower source routing control overhead compared to RPL. Our results also provide new insights into the performance of MP2P, P2MP, and P2P communications relative to RPL’s destination-oriented directed a-cyclic graph (DODAG) depth, i.e., a deeper DODAG negatively impacts the performance of MP2P and P2MP communications, however it positively impacts P2P communication, while the reverse holds true for a relatively shallow DODAG.

Performance Evaluation of RPL Objective Function: A Case of Contiki Operation System

“…WSN supports three traffic types: Point-to-Point -P2P (between devices inside the LLN), Point-to-Multipoint -P2MP (between the central device and other devices inside LLN), and Multipoint-to-Point -MP2P (between the devices inside the LLN to a central device) [6]. See Fig 1 . A routing protocol or mechanism is used to transport data from one point to the other in the network.…”