Reconstruction of Lamb Wave Dispersion Curves in Different Objects Using Signals Measured at Two Different Distances

Abstract

The possibilities of an effective method of two adjacent signals are investigated for the evaluation of Lamb waves phase velocity dispersion in objects of different types, namely polyvinyl chloride (PVC) film and wind turbine blade (WTB). A new algorithm based on peaks of spectrum magnitude is presented and used for the comparison of the results. To use the presented method, the wavelength-dependent parameter is proposed to determine the optimal distance range, which is necessary in selecting two signals for analysis. It is determined that, in the range of 0.17–0.5 wavelength where δcph is not higher than 5%, it is appropriate to use in the case of an A0 mode in PVC film sample. The smallest error of 1.2%, in the distance greater than 1.5 wavelengths, is obtained in the case of the S0 mode. Using the method of two signals analysis for PVC sample, the phase velocity dispersion curve of the A0 mode is reconstructed using selected distances x1 = 70 mm and x2 = 70.5 mm between two spatial positions of a receiving transducer with a mean relative error δcph=2.8%, and for S0 mode, x1 = 61 mm and x2 = 79.7 mm with δcph=0.99%. In the case of the WTB sample, the range of 0.1–0.39 wavelength, where δcph is not higher than 3%, is determined as the optimal distance range between two adjacent signals. The phase velocity dispersion curve of the A0 mode is reconstructed in two frequency ranges: first, using selected distances x1 = 225 mm and x2 = 231 mm with mean relative error δcph=0.3%; and second, x1 = 225 mm and x2 = 237 mm with δcph=1.3%.

Guided waves based damage localization based on mode filtering using fiber Bragg grating sensors

“…But for the use of this technique full wavefield information is necessary. Signal processing techniques such as ones by Draudviliene et al [21] try to overcome the need for large number of measurement points, by restricting to two measurement points. But even then requirement of multiple measurement locations is a shortcoming.…”