Rational synthesis of 10GDC electrolyte through a microwave irradiation GNP facile route for SOFC applications

Shaikh, Shabana P.S.; Rode, Chandrashekhar V.

doi:10.1039/c9ra09476h

Cited by 4 publications

(1 citation statement)

References 47 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The GDC nanoparticles had a d -spacing value of approximately 2.71 Å, and the YCF crystal had a d -spacing value of approximately 2.57 Å, which were corresponding to the d-values from the XRD data (JCPDS nos. 01-075-0161 and 43-1036, respectively). , A single YCF–GDC core–shell fiber is illustrated in Figure S3 (Supporting Information), which also confirms the GDC nanoshell and core–shell microstructure.…”

Section: Resultssupporting

confidence: 57%

Electrospun Core–Shell Fibers for High-Efficient Composite Cathode-Based Solid Oxide Fuel Cells

Yang

Wang

et al. 2021

Energy Fuels

View full text Add to dashboard Cite

Fibrous perovskite oxide has been the most promising cathode for intermediate-temperature solid oxide fuel cells (IT-SOFCs) due to its efficient mass and charge transfer. Herein, a core−shell fiber-structured YCo 0.5 Fe 0.5 O 3 (YCF)− Gd 0.1 Ce 0.9 O 1.95 (GDC) cathode is synthesized via the modified electrospinning technique. These unique YCF−GDC fibers exhibit a uniform diameter of 300 nm, and the GDC particles are attached to the YCF fiber cores. The electrochemical performance demonstrates a relatively low area-specific resistance of 0.66 Ω•cm 2 at 550 °C in air, which is much lower than 1.56 Ω•cm 2 of pure YCF fiber cathode. Moreover, the distribution of relaxation times (DRT) analysis results indicate that the introduction of GDC nanoparticles and the core−shell structure greatly facilitate oxygen-ion conduction and charge transfer processes, and the oxygen incorporation process plays a major role in the total polarization resistance. The NiO−GDC|GDC|fibrous YCF−GDC fuel cell shows a maximum power density of 426.5 mW•cm −2 at 550 °C. These results display that the core−shell fiber-structured YCF− GDC composite oxide is a promising candidate of highly active cathode for IT-SOFCs.

show abstract

Section: Resultssupporting

confidence: 57%

Electrospun Core–Shell Fibers for High-Efficient Composite Cathode-Based Solid Oxide Fuel Cells

Yang

Wang

et al. 2021

Energy Fuels

View full text Add to dashboard Cite

show abstract

An investigation and analysis of structural and electrochemical properties of highly ionic conductive La2−xSrxSn2O7−δ electrolyte for SOFC applications

et al. 2023

View full text Add to dashboard Cite

Advances in the knowledge of the double perovskites derived from the conformation and substitution of the material Sr2MgMoO6-δ as anode with potential application in SOFC cell

Flores

Rodríguez

Vera

et al. 2021

International Journal of Hydrogen Energy

View full text Add to dashboard Cite

Rational synthesis of 10GDC electrolyte through a microwave irradiation GNP facile route for SOFC applications

Abstract: The gadolinium-doped ceria Gd0.1Ce0.9O1.95 (10GDC) powder was synthesized using a microwave-synthesized glycine nitrate process (MS-GNP).

Cited by 4 publications

References 47 publications

Electrospun Core–Shell Fibers for High-Efficient Composite Cathode-Based Solid Oxide Fuel Cells

Electrospun Core–Shell Fibers for High-Efficient Composite Cathode-Based Solid Oxide Fuel Cells

An investigation and analysis of structural and electrochemical properties of highly ionic conductive La2−xSrxSn2O7−δ electrolyte for SOFC applications

Advances in the knowledge of the double perovskites derived from the conformation and substitution of the material Sr2MgMoO6-δ as anode with potential application in SOFC cell

Contact Info

Product

Resources

About